You’d probably need a decent piece of steel. Put a piece of angle iron on the floor jack pad and it should split/destroy the concrete . You could also use a standard hydraulic jack (they are very cheap, 20 tons or more for little $) if you can find a place to brace the jack and concrete you’re working on.
How do you remove concrete from fence posts?
How do you separate concrete and metal?
If you’re talking about concrete that came from a mix that accidentally was left on a piece of steel that’s simple. Just hit it with a hammer with a glancing blow . That will knock it off.
How do you remove a metal fence post from the ground without digging?
Saturate the ground around the base of the post with water from a garden hose. Let the water soak in until the ground is muddy. Wiggle the post back and forth to loosen it. Even if it doesn’t move very much, any amount of loosening of the soil around the base will make it easier to remove.
How do you remove an aluminum fence post in concrete?
How do you remove a metal fence post spike?
How do you remove metal T post?
How do you remove concrete from concrete?
How do you make concrete remover?
Mix bleach with water and then add dishwashing detergent to the mix and put it into a spray bottle. Spray the solution onto the cement patio, let it sit for a few minutes, then scrub the mix into the concrete with a stiff brush.
How do I remove concrete fence posts UK?
It’s probably 18-24′′ in the ground and set in concrete. If you do need to remove it, dig down one side of it with a narrow spade (or better still a trenching tool) and lever it into the hole you’ve just made – sufficient to loosen it enough to remove. It will be heavy – try to set up some form of lever to lift it out.
How do you remove a metal fence?
To remove a chain-link fence, start at one end or corner post and remove the nut and bolt on the clamps that hold the fence fabric to the post. Weave the metal bar out from the chain link, then use pliers to remove the fence ties a few at a time. Lay the chain fence fabric flat on the ground as you go.
How do you remove metal from chain link fence posts?
How do you remove a metal pole from the ground?
How do you remove T bar fence posts?
Place your JackJaw fence post puller beside the T-post you plan to remove. You will put the puller’s hook underneath one of the winged edges of the T-post. From there, push the JackJaw arm down and leverage the end of the T-post up. You will then move to the other side of the T-post and repeat the same process.
How do I make a post puller?
How do you remove T posts with Jack?
Does anything dissolve concrete?
Concrete is a durable building material that takes special materials to dissolve once it’s hardened into place. Phosphoric acid and trisodium phosphate are the main compounds used to dissolve concrete leftover from masonry work .
Does vinegar dissolve concrete?
Etching – Vinegar’s ability to dissolve CaCO3 will dull your marble, travertine, concrete and terrazzo surfaces . It may “clean” the surface but it is also dissolving pits into the finish and effectively dulling it.
How do you remove cement from steel railing?
- Rinse splashes off immediately.
- Use a 10%–15% phosphoric acid-based solution in warm water.
- Spread cleaner evenly, wait 30–60 minutes, then neutralize the acid with an alkaline cleaner or diluted ammonia.
- Rinse with clean water.
