We carry both standard clutches as well as mini bike racing clutches
. We have 3/4′′ clutches for Predator 212cc engines, 1′′ clutches for Predator 420cc engines, as well as for all other engines with a 3/4′′, 1′′ bore, or 5/8′′ shaft. The most popular mini bike clutch brands we carry are Max Torque, Noram, and Hilliard.
What does a clutch do on a mini bike?
The clutch is the part of your bike that
disengages the power from the engine to the transmission
. You will use your clutch when trying to shift gears or when you need to bring your dirt bike to a standstill so that your engine does not stall when it is not in gear.
How do you put a clutch on a Coleman mini bike?
Why is my centrifugal clutch smoking?
When a part of your go-kart is smoking, an investigation into the reason is required before more damage occurs. The most common cause, usually the main culprit, is that
the clutch is engaging, but it’s not fully grabbing
. It is generally due to the engine not being powerful enough to get through the engagement stage.
How do you put a clutch on a 212cc Predator engine?
- Oil or Greese the bushing of the clutch.
- Insert a 3/4“ spacer or washers on the Crankshaft.
- Place the Clutch into the Crankshaft by aligning the key of the clutch and the slot in the shaft.
- Tighten the bolt.
What is the best mini bike clutch?
- FDJ Minibike Go Kart Clutch – Best Value for Money.
- Max Torque – Best Quality.
- Auto Express Centrifugal Clutch – Best for #35 chain.
- DEDC Centrifugal Clutch – The Cheapest.
- Hilliard Extreme Duty Clutch – Best Alternative Design.
How long does a mini bike clutch last?
However, if it’s improperly installed, driven in abusive conditions (sand, steep terrain, excessive weight in the kart or rear tires taller than 15”), the clutch might only last
20 minutes
.
How can I make my mini bike faster?
What size is the clutch on a Coleman mini bike?
Clutch details:
OD: 107mm [4.23′′]
10-tooth gear.
Where do you oil a centrifugal clutch?
How do you take the clutch off a mini bike?
When should I use clutch on bike?
You should Always clutch so as
to prolong the life of the bike transition, and other parts
. If you shift straight to a higher gear without clutching you may stall the bike or cause gear damage. Practice makes perfect. Hitting neutral on some bikes can be difficult when it is between first and second.
Do you need to use clutch on a dirt bike?
Do you have to use the clutch when downshifting a dirt bike?
No, you don’t have to pull in the clutch
. To downshift, just let off the throttle, click down on the shift lever and then you can apply throttle or brake again. The clutch does make downshifting slightly smoother.
Does popping the clutch hurt your dirt bike?
Its fine to pop it,
wont do any damage
.
How long does a centrifugal clutch last?
Improper installation of the centrifugal clutch can result in its failure as quickly as in a couple of minutes. Still though, even if installed properly, it won’t last more than
five years maximum
.
Why is my centrifugal clutch getting hot?
Your clutch may be overheating due to several reasons. One of the most common reasons is a
lack of lubrication
. If your clutch is not lubricated properly, there is no agent that helps to reduce friction and disseminate heat.
How do you break a centrifugal clutch?
Engage the clutch and bring the temp up to about 250 degrees and then allow it to cool down, engage the clutch again and bring the temp up to about 300 degrees and again allow it to cool down. Continue this process until you bring the clutch up to approximately 400 degrees.
What is the top speed of a 212cc Predator engine?
Expect a 212cc engine to be able to reach a max speed of
between 30mph and 50mph
. The obtainable speed is determined by the application of the engine (bike or kart) as well as the load it’s carrying.
What clutch goes on a Predator 212?
As you can see, the Predator 212cc engine has two compatible centrifugal clutch that can be used: the
10T & 3/4′′ Clutch and the 12T & 3/4′′ Clutch
.
Does a Predator 212 come with a clutch?
Yes it will fit the Predator 6.5 HP 212cc engine. You will have to get set screws though
the clutch doesn’t come with them
.
How much HP can a centrifugal clutch handle?
NORAM centrifugal clutches are designed to fit engines ranging from
fractional horsepower up through 50 HP
applications.
Do I need a clutch on a go-kart?
Most off-road and racing go-karts use a transmission, unless they have a direct drive configuration
. A transmission provides controlled mechanical power from the engine to the rear axle of the go-kart. You’ll most likely come across go-karts that use a torque converter or a clutch, as a transmission.
How do you install a centrifugal clutch?
Do motorcycle clutches wear out?
Motorcycle clutches utilize steel and fiber plates to engage the clutch.
The steel plates rarely wear out
, but the fiber plates wear down like brake pads every time the clutch engages. In most cases, fiber plates will grow thinner and discolor as they wear out.
How do you know if your clutch is bad on a motorcycle?
To tell if your motorcycle clutch is bad, you’ll need to look for signs such as
unexplained high revs and lowered gas mileage
. Other signs of a bad clutch may also include a stuck clutch lever, hard shifts accompanied by a clunking sound or jerk, and difficulty getting the motorcycle to shift gears.
How do I know if my clutch plate is worn?
- Slipping. This is exactly what it sounds like. …
- Burning smell. A burning smell many times goes hand-in-hand with a failing clutch. …
- Noises. …
- Sticky or stuck pedal.
