A toe board is like a tiny wall – usually between 4 and 12 inches – whose purpose is
to prevent objects or people from falling over, or rolling over, the side of a raised platform
, such as preventing a screwdriver dropped on the floor of elevated construction scaffolding from rolling off the side onto people or objects …
When should toe boards be used?
You must fit toe board to the working platform and any other platform where
a risk assessment
has shown that there is a danger of materials falling from that platform and injuring a person below. That risk may exist even at low platform heights.
What is the purpose of a toe board?
Toeboards are
protective barriers
that are placed near the ground or walking surface. They are often used when there is a risk that tools or other objects could fall onto a person from a platform or other raised area, or through a floor opening or hole.
Are toe boards mandatory?
While some of OSHA’s revised walking-working surface regulations
require toeboards as part of a guardrail
, they are not mandatory with every guardrail. … Still, including them on guardrails may be a good idea if they could be needed in the future to protect workers from falling objects.
Why are scaffolding toe boards required?
Toe-boards and handrails work in unison by protecting workers and equipment, both at the top and the bottom of the scaffold platform. … The purpose of toe-boards is basically the same as handrails –
to prevent workers, equipment, and materials from slipping or being knocked off the scaffold platform
.
Which is true about toe boards?
A standard toeboard shall be
4 inches nominal in vertical height from its top edge to the level of the floor
, platform, runway, or ramp. … It may be made of any substantial material either solid or with openings not over 1 inch in greatest dimension.
In what sport would you use a toe board?
(athletics) In throwing sports such as
javelin and shot put
, a board on the ground, over which the thrower must not step.
At what height do you need toe boards?
Toe boards should have a minimum height of
150mm
, however typically on tube and fitting scaffold structures toe boards are 225mm scaffold boards.
What is the maximum gap allowed under a toe board?
Section 321 limits to
no more than 6 millimetres the height of
the gap between a walking or working surface and the bottom of the toe board.
At what height are you considered to be working at height?
Work at height means work in any place where, if precautions were not taken, a person could fall a distance liable to cause personal injury. You are working at height if you: work above
ground/floor level
.
could fall from an edge
, through an opening or fragile surface or.
How high can a platform be without handrails?
29 CFR 1926.500(d)(1) requires every opensided floor or platform
6 feet or more above
the adjacent floor or ground level to be guarded by a standard railing or the equivalent on all open sides, except where there is an entrance to a ramp, stairway, or fixed ladder.
What is the OSHA standard for fall protection?
OSHA requires that fall protection be provided at elevations of
four feet in general industry workplaces
, five feet in shipyards, six feet in the construction industry and eight feet in longshoring operations.
Which fall protection is not allowed at a leading edge?
Each employee on a walking/working surface 6 feet (1.8 m) or more above a lower level where leading edges are under construction, but who is not engaged in the leading edge work, shall be protected from falling by
a guardrail system, safety net system, or personal fall arrest system
.
Which of the following best defines a toe board?
- a : the sloping boards in the floor of an automotive vehicle in front of the forward seat.
- b : a curved piece of wood fastened to the ground at the front of the circle used for shot putting, throwing the weight, or similar contests to prevent overstepping.
What is a toe board on stairs?
Toe boards also
help protect workers from falling off elevated walking-working surfaces
. In general, OSHA toe board requirements are in place to ensure a vertical barrier whenever handrails are used with the potential of tools or objects falling from the edge.
