What Does D3 Light Mean On Honda CRV?

by | Last updated on January 24, 2024

, , , ,

The D3 light on Your Honda CR-V is a lamp that will illuminate in the tachometer when You have selected D3 on the gear selector. … If the D3 light is flashing on Your car while You are driving at highway speeds then that can mean that

there is a problem with the overdrive gear

.

What does D3 mean on Honda?

D3 is not a

service code

. It is an indicator that lights-up to the right of the “D” (Drive) indicator on the dash, when you push the button on the end of the shift level. When lit, the transmission will only shift into the lowest 3 gears. It is used when hauling heavy loaded trailers or over large hills/mountains.

What does code D3 mean on Honda CRV?


Drive

(D3) – This position is similar to D4, except only the first three gears are selected. Use D3 to provide engine braking when going down a steep hill. D3 can also keep the transmission from cycling between third and fourth gears in stop-and-go driving.

Why is my car in D3?

The D3 you see in an automatic transmission means

Drive 3

. This gear engages and locks the third gear so it won’t shift automatically to other driving gears.

Can driving in D3 damage your car?


actually no damage at all

. For my car to cause damage driving around in third gear (5 speed manual) I’d need to be doing more than 90, and in the equivalent gear to your third (my fourth) I’d need to be doing around 130. Depending on where your redline is, you’re likely higher.

Can you shift from D to D3 while driving?

The person who said the shift points are higher in D3 is wrong. What you should not do, espeically on the freeway, is

shift down into D3 with your

foot off the accelerator. You want to be giving the car gas while downshifting so that it does rev up and slow down.

How do you turn off D3 on Honda CRV?


Press the D3 switch on the side of the shift lever

to turn this mode on or off; the D3 mode indicator comes on whenever the D3 mode is selected. D3 mode can be turned on or off only when the ignition switch is in the ON (II) position and the shift lever is in the D position.

Can I drive my car in 3rd gear?

The actual answer depends upon the final transmission output gear ratio.

If fourth is an overdrive gear (less than 1:1, say 0.7:1), it is fine to drive in 3rd

and even recommended in some situations to improve driving experience and vehicle performance (examples – stop and go traffic, towing).

What does drive 3 mean?

For example, in a four-speed, selecting 3 would

allow the automatic transmission to shift among 1st gear

, 2nd gear and 3rd gear, but 4th gear would be locked out, accessible only by selecting Drive.

What gear do you use when going uphill in an automatic?

Step 1: Use the right drive gears.

While going uphill, use

the D1, D2, or D3 gears

to maintain higher RPMs and give your vehicle more climbing power and speed. Note: Most automatic vehicles have at least a D1 and D2 gear, while some models also have a D3 gear.

Is D3 faster than D?

The only thing

D3 does faster is drink fuel at 60MPH

, all you are doing is turning the overdrive off. D is not a overdrive. It’s just another gear.

What does D mean in automatic cars?

The “D” stands for

DRIVE

. … As the vehicle begins to slow down, the automatic drive gear will down-shift to lower gears. The “D” is also commonly referred to as ‘overdrive.

When should I use 3rd gear?

3 – Third gear

To be used when

you require more power but less speed

and to prevent the transmission from shifting to a higher gear. These gears may be used when going up or down hills and on road conditions like slush, loose gravel, snow, sand or ice, where you need more power but less speed.

What is D3 good for?

Vitamin D3, also known as cholecalciferol, is a supplement that helps your body absorb calcium. It’s typically used to treat people who

have a vitamin D deficiency or related disorder

, such as rickets or osteomalacia. Some individuals who might need extra vitamin D include: Older adults.

Does driving in D3 save gas?

You’re essentially locking out the overdrive gears by using D3.

It’s not likely you’d save any gas

, it’s really more appropriate to be used during conditions where the tranny is continuously shifting in/out of OD. Better on the transmission to leave it in a lower gear, but that won’t help mpg.

How fast should you go in 3rd gear?

Gear Speed 1st gear Between 0 mph and 10 mph 2nd gear Between 10 mph and 20 mph 3rd gear

Between 20 mph and 30 mph
4th gear Between 30 mph and 40 mph
Charlene Dyck
Author
Charlene Dyck
Charlene is a software developer and technology expert with a degree in computer science. She has worked for major tech companies and has a keen understanding of how computers and electronics work. Sarah is also an advocate for digital privacy and security.