- See a zone change.
- Check all of your zones.
- Create time and space by getting the best speed control, lane position, and communication.
What is the zone control system?
The zone control system is
an organized method for managing six zones of space surrounding your vehicle
. The zone control system allows you to see and respond to changes in the traffic environment at a time when best control can be achieved.
What are the three vehicle managing zones?
- Zones 1, 2 and 3 cover the space in front of your vehicle.
- Zones 4, 5 and 6 cover the space behind your vehicle.
- Zones 1 and 6 are in the same lane as your vehicle.
- Zones 2 and 4 are in the lane to your left.
- Zones 3 and 5 are in the lane to your right.
What are the three main actions you can execute when driving?
The three important actions to execute are
controlling sped, steering, and communication
.
What is the first step to the zone control system?
The first step in the Zone Control system is
to use good searching strategies to find the LOS-POT blockages that will cause a zone closure
.
What is a path of travel?
Path of travel is
the series of continuous positions your vehicle takes in the process of moving to your target
. While driving straight ahead you will normally stay in the middle of a driving lane unless other factors affect the position of your car and change your path of travel.
What are the four steps in the IPDE process?
- I—Identify—Locate potential hazards within the driving scene.
- P—Predict—Judge where the possible points of conflict may occur.
- D—Decide—Determine what action to take, when, and where to take it.
- E—Execute—Act by maneuvering the car to avoid conflicts.
What is the purpose of zone control system?
A zone control system gives
you control over the temperature in each room in your house using only single zone
unitary HVAC equipment. The zone control system warms or cools the rooms you use the most at the time you use them.
What are the 6 zones of control?
There are six areas of space around a vehicle:
front left, front, front right, rear left, rear, and rear right
.
What is the process of zone control?
Zone control systems consist of
air duct dampers that control internal facility climate according to preset temperature settings
. … These thermostats send signals through control panels, triggering dampers to either open or close until they achieve the desired temperature.
What does the R in safer stand for?
SAFER stands for
Space, Attitude, Foresight, Eyesight and Responsibility
.
What is the safest position in traffic drivers ed?
Lane position one
is your primary or “default” position, as it is the safest position to drive in under normal circumstances. Your vehicle is in lane position one when it is central, with at least three feet of space between the sides of the car and the left and right lines.
What is a changing zone?
What is a changing zone?
an open zone that may change to a closed zone
.
What does good zone control mean?
By directing the flow of heat only to areas where it is needed, zone control systems prevent the heater from spending energy heating the unused areas of the house. This means that the
heater spends less energy overall
, which translates to savings on your heating bill.
Does a poorly running engine pollute the air?
A poorly running
engine may pollute the air
. A good rule of thumb for the side mirrors is to set them so that when you lean forward slightly, you can see the bottom of your vehicle.
What is the space your vehicle will occupy?
path of travel
: This is the space your vehicle will occupy as you travel ahead. target area: Your target is the aiming point where you want to go. The target area is the section of the roadway where the target is located and the area to its right and left.
