Press and hold both the brake and gas pedals simultaneously until you see a message on the dash monitor that reads “
service
: reset oil in prog.” Proceed for 20-25 seconds to click the brake and gas pedals, until the dash indicator reads, “service: full oil reset.” Engine start. The oil light turns off.
How do you clear the service message on a Ford Focus?
- Turn the ignition key to the on position. …
- Press both the accelerator and brake pedals at the same time.
- Keep both pedals fully pressed.
- After three seconds, the Service: Oil reset in prog message will be displayed. …
- .
How do I get rid of service due light?
Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
How do you reset the service light on a 2010 Ford Fiesta?
- Switch the ignition “ON“. …
- Press the “Gas” and “Brake” pedals all the way down at the same time.
- After about 3 seconds, a message should appear on the instrument panel that says the oil light will be reset.
- Continue to hold both pedals.
How do I turn the service light off on my dashboard?
- Open the hood of your vehicle. …
- Loosen the nut that holds the negative terminal to the battery with the pliers. …
- Completely remove the cable from the negative battery terminal. …
- Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.
How do I reset dashboard after oil change?
Insert the key into the ignition and turn it to the “on” position without starting the engine. Press the the
gas pedal slowly to the floor three successive times within 10 seconds
. Turning the ignition off. If the light is still on the next time you start the truck, repeat the process.
Why is my maintenance required light still on after oil change?
Most often this just means your vehicle might be due for an oil change. The light will come on and remain on
if the distance driven exceeds 5,000 miles after the maintenance data has been reset
.
What is the service interval for a Ford Focus?
| Engine oil When indicated or every 12-months | Engine air filter Every 30,000 miles | Coolant After 100,000 miles |
|---|
How do you reset the service light on a 2016 Ford Focus?
- Turn the ignition key to the on position. …
- Press both the accelerator and brake pedals at the same time.
- Keep both pedals fully pressed.
- After three seconds, the Service: Oil reset in prog message will be displayed. …
- .
How do you turn off the service light on a Ford Fiesta?
Turn on the ignition (not the engine). 2.
Hold down the brake and accelerator for twenty seconds until the warning light goes off
.
How do you reset the service light on a Ford Fiesta?
- Switch the ignition “ON“. …
- Press the “Gas” and “Brake” pedals all the way down at the same time.
- After about 3 seconds, a message should appear on the instrument panel that says the oil light will be reset.
- Continue to hold both pedals.
How do you reset car sensors?
To do this, insert your key into the ignition, turn the vehicle on for about a second, and then off for about a second. Repeat this two more times then drive the car as normal. Check to see if the check
engine light reset
.
How do I turn off the oil life indicator?
Insert the key in the ignition and turn the key to the accessory position. At this point, the instrument panel will illuminate. Next, depress the accelerator pedal to the floor within the first five seconds of turning the key.
Keep your eye on the oil light
, as it should flash before turning off.
How do I reset my car lights?
- Open the hood of your vehicle. …
- Loosen the nut that holds the negative terminal to the battery with the pliers. …
- Completely remove the cable from the negative battery terminal. …
- Leave the battery disconnected for 10 minutes to ensure that the computer is fully reset.
