- Find Oil Drain – Locate the oil drain plug underneath the vehicle. …
- Find Oil Filter – Locate the oil filter. …
- Remove Oil Cap – Take off the oil fill cap. …
- Replace Cap – Put the oil fill cap back on the engine. …
- Car Displayed: 2011 Ford Escape XLT 3.0L V6 FlexFuel.
What oil does a Mercury Mariner take?
| Viscosity: 5W-20 (All TEMPS) | Capacity: 4.8 quarts (with filter)After refill check oil level. | Torque: 21 ft/lbs (Oil Drain Plug) |
|---|
How much oil does a Mercury Mariner take?
| Viscosity: 5W-20 (All TEMPS) | Capacity: 6 quarts (with filter)After refill check oil level. | Torque: 19 ft/lbs (Oil Drain Plug) |
|---|
How do you change the oil on a 4 stroke Mercury outboard motor?
Step 8. Remove the filler cap from the back of the powerhead, then fill the outboard with
3 quarts
of Mercury 4-stroke marine engine oil and replace the filler cap.
How do you change the oil on a 2010 Mercury Mariner?
Capacity:
5 quarts
(with filter)After refill check oil level.
What kind of oil does a 2010 Mercury Mariner take?
Mobil 1 Extended Performance Synthetic Motor Oil 5W-20
1 Quart.
How much oil does a 2010 Mercury Mariner take?
Capacity:
5 quarts
(with filter)After refill check oil level.
What kind of oil does a 2008 Mercury Mariner use?
Mobil 1 Extended Performance Synthetic Motor Oil 5W-20
1 Quart.
What oil does a 2006 Mercury Mariner take?
| Viscosity: 5W-20 (All TEMPS) | Capacity: 6 quarts (with filter)After refill check oil level. | Torque: 19 ft/lbs (Oil Drain Plug) |
|---|
What kind of oil does a 2009 Mercury Mariner take?
Castrol Edge Synthetic Motor Oil 5W-20
1 Quart.
What type of oil goes in a Mercury lower unit?
Mercury Premium SAE 80W90 Gear Lube
is recommended for lower units for outboards below 75 horsepower. Mercury Premium SAE 80W90 Gear Lube should not be mixed with Mercury High-Performance SAE 90 Gear Lube.
How much oil does a 40 hp Mercury outboard take?
Remove the filler cap from the back of the powerhead, then fill the outboard with
3 quarts
of Mercury 4-stroke marine engine oil and replace the filler cap.
How much oil does a 150 Mercury 4 stroke?
| Model US Crankcase Capacity | 150 FourStroke EFI, 1B905505 and up 6.34 QT. (211 oz.) | 135 Verado 4 cylinder 6.34 QT. (211 oz.) | 150 Verado 4 cylinder 6.34 QT. (211 oz.) | 175 Verado 4 cylinder 6.34 QT. (211 oz.) |
|---|
How do you reset the change oil light on a 2010 Mercury Mariner?
- Turn the ignition to run, one position before starting engine.
- Press the SET control to access the system check function.
- Press and release the SETUP control to display “OIL LIFE = XXX% HOLD RESET = NEW”.
- Press and hold the RESET control for two seconds and release.
How much oil does a 2009 Mercury Mariner take?
Capacity:
5 quarts
(with filter)After refill check oil level.
How much oil does a 2007 Mercury Mariner take?
Capacity:
6 quarts (with filter)
When refilling, remove dipstick to provide adequate venting and allow oil to flow into crankcase. After refill, check oil level.
