How Do You Change A Speedometer Cluster?

1. Set the parking brake.
2. If your gear shifter is on the steering column, move it down to the lowest setting possible. …
3. Tilt the steering wheel as low as you can.
4. Remove the dashboard panel in front of the instrument cluster. …
5. If necessary, disconnect the wires behind the panel.

How do I know if my instrument cluster is bad?

1. Dim instrument cluster lights.
2. The check engine light coming on sporadically or permanently. …
3. Intermittent failure of the gauges.
4. Inaccurate gauge readings. …
5. Blinking lights.
6. The lights glowing up or lighting up every now and then.

How much does it cost to replace instrument cluster?

The average cost for an Instrument Cluster Replacement is

between $792 and $812

but can vary from car to car.

How do you remove instrument clusters?

Lower the front slightly and pull towards the steering wheel. Once removed it will expose a single screw to the left of the steering column. Remove screw to the left of steering column. The entire dashboard may now be removed by

pulling

from around cluster, radio and steering column.

Does a new instrument cluster need to be programmed?

The cluster does not need to be programmed

however you need a cluster from a supercharged car otherwise the display will show incorrect part fitted, also the connector on 1999 & 2000 cars are not the same.

Can I drive my car without the instrument cluster?

Yes

, you can still start and run your vehicle without the instrument cluster.

Is it hard to replace an instrument cluster?

Changing the instrument cluster is a

relatively easy process

and can be attempted by anyone who is familiar with a basic set of tools. There are a few things that can go wrong but the steps are still considered simple by most mechanics. Put aside roughly an hour to an hour and a half for this job.

What problems can a bad instrument cluster cause?

Signs of a bad instrument cluster include dim/flickering gauges, inaccurate or unreliable readings, all gauges dropping to zero while driving, and

an unworkable instrument cluster

. These error symptoms can result in your vehicle going out while driving, displays failing occasionally, or complete/intermittent failure.

Can a instrument cluster be fixed?

We specialize in the repair of instrument clusters, repairing thousands of units annually. Our highly skilled technicians can troubleshoot failures and make repairs that restore your instrument clusters to like-new condition. No programming is required, and your odometer will retain the correct vehicle mileage.

Why is my cluster not working?

As stated above, a defective instrument cluster and a blown fuse are common reasons. … There are tons of configurations and instrument cluster designs out there. If it happens that all your

gauges stop working at the same time

, the problem is only caused by two things. It’s either by a wiring problem or a fuse problem.

How do you test an instrument cluster?

1. Dim instrument cluster lights.
2. The check engine light coming on sporadically or permanently. …
3. Intermittent failure of the gauges.
4. Inaccurate gauge readings. …
5. Blinking lights.
6. The lights glowing up or lighting up every now and then.

Does changing instrument cluster change mileage?

So does changing an instrument cluster mean changing your mileage? The short answer is

no

. Replacing the instrument or gauge cluster won’t reset the mileage.

Can a bad instrument cluster cause loss of power?

3. Inoperable instrument cluster. An inoperable instrument cluster is another symptom of a possible issue with the vehicle’s instrument voltage regulator.

If the instrument voltage regulator fails completely, power to the cluster will be disabled and it will cease to function

.

How do I reset my instrument cluster?

Push and release the

Sel/reset button button

3 times repeatedly. The instrument cluster begins its self-test. Each successive press of the Sel/reset button initiates a new cycling of all the gauges. To end, turn the ignition switch to OFF, or vehicle speed exceeds 1.5 mph.

Where is the fuse for the instrument cluster?

The instrument panel fuse block is located in

the instrument panel

, on the driver side of the vehicle. To access the fuses, open the storage compartment. Press in on the sides of the compartment to release it from the instrument panel.