To unlock the panel,
press “Time”, “Jets 1” and then “Cool”.
How do I reset my hot tub control panel?
- Locate the spa's high-limit reset. This is a red button found on many spa packs. …
- Press the high-limit reset button. …
- Turn on your spa and observe its operation. …
- Flip the breaker panel switch on or press the reset button on the GFCI outlet to restore power.
How do I turn my spa lock off?
Spas using Spa Power systems
You will need to hold the buttons down for about three seconds before the lock is activated. At this point, the touchpad beeps and displays “Keyboard Lock”. Unlocking:
Press “Down”, then “Scroll”, “Down”, “Up” and finally “Scroll”.
Why is my hot tub control panel not working?
Bottom line is – it
could be a bad spaside control panel
, or it could be a bad spa control board, or a bad cable that runs between the control panel and the control board. Or it could be fuse on the circuit board or the transformer, not sending the correct power to the topside panel.
How do I unlock my spa control panel?
To unlock the panel,
press “Time”, “Jets 1” and then “Cool”.
How do I get my hot tub out of Protect Mode?
It will do this because the heating element is still hot, and when the power is lost, the hot element will continue to heat the water inside the heater. When power is restored, it reads that water temp as too hot inside the heater, and trips the high limit, requiring you to power down and reboot.
How do I test my hot tub control panel?
If the problem persists, turn the breaker off and disconnect the panel to examine the circuit board. Turn the power on and check if the hot tub heats up or starts to filter. The surest way to check if a control panel works is to use one you know is
working and connect it to the circuit board
.
The High Limit Reset Button is located
behind the gas valve
.
Press the red reset button to reset the switch before reaching out to tech
support. Make sure the temperature probe is properly in the right amount of water to accurately read the temperature, and that there is no build up in the thermal well.
How do I get rid of hot tub control panel?
- Step 1: Turn Off the Power. …
- Step 2: Break the Silicone Mounting Seal. …
- Step 3: Unplug Upper Control Connector. …
- Step 4: Remove Old Silicone. …
- Step 5: New Connector. …
- Step 6: Press New Panel. …
- Step 7: Turn On Power.
How do I know if my hot tub circuit board is bad?
An icon or indicator light should display
, when you activate any component on your spa. If not, the trouble is with the topside control, but if you do see the icon/light come on, but the pump/heater/blower/light is not actually working, the issue could be with the spa component, or the spa circuit board.
How do you reset a strong spa?
Press the RESET button on the GFCI
. The GFCI will reset and the spa will turn back on. The spa is now safe to use. If the GFCI trips while the spa is in use, press the RESET button.
How do I know if my hot tub has an airlock?
As mentioned above, the most common sign that your hot tub has an air lock is
the jets not working when powered on
. This can include nothing coming out of your jets when they are turned on or even a humming sound coming from the jets or pump.
How do I reset the high limit switch on my hot tub?
Occasionally, the high limit switch will trip when you're filling your spa. Or it might need a reset from time to time for no known or serious reason. Simply reset
by pressing the big red button on your spa pack
. The high limit switch may be housed in a thermowell.
How do I unlock my hotspot Spa?
To lock/unlock the spa,
press the “set” button
and then (the word “set” will be flashing) press “temperature up” button once, wait 10 seconds before pressing any other buttons.
