Should be
next to the air filter box
, on the drivers side, under a plastic casing. The fuel pump is also on the drivers side frame rail, near the transmission crossmember. The fuel filter is between the fuel tank and the fuel pump.
Where is the fuel pump relay located on a 1985 Ford f150?
Thanks very much for pointing out where the fuel relay is. You are correct it is
just behind the air cleaner housing
.
Where is the fuel relay switch located at?
Location. Most fuel-pump relay units are located
under the dashboard near the steering column
. In some cases, the unit is located in the area where the steering column is mounted or near the engine’s firewall.
Where is the fuel pump relay on a Ford?
The fuel pump relay of a Ford pickup, also known as the fuel shut off switch, is located in
the passenger foot well, behind the behind the kick panel and inside the fuse panel
.
Where is the fuel pump reset switch on a Ford f150?
Reset the fuel pump cut-off switch by pressing the small, round button, located near the passenger-side kick panel,
underneath the right-side portion of the glove compartment
.
How do you test a Ford fuel pump relay?
- Park the car in safe and level ground. …
- Step 2: Turn the ignition key in the ON position but don’t start the car. …
- Step 3: Raise the hood and locate the fuel pump relay. …
- Step 4: The fuel pump relay will emit a clicking or buzzing sound when turning the key in the ON position.
Where is the inertia switch on a 1987 Ford f150?
I have an 1987 and the inertia switch is
Drivers side behind clutch pedal
.
Look for the fuel pump switch or inertia switch. This is a small box with a plastic button on top and an electrical connector at the bottom. On some vehicle models, this will be located in
the luggage compartment
. Look on a side panel for a small, round button which you can pry off with a small screwdriver.
Is it the fuel pump or the relay?
The
fuel pump relay
is an electronic component that is found on virtually all vehicles equipped with an internal combustion engine. It is often found in the fuse box located in the engine bay and functions as the primary electronic switch that controls power to the fuel pump.
What are the symptoms of a bad relay?
Car suddenly stalls while operating
: One of the most common symptoms of a failed ignition relay is a car that suddenly stalls while operating. If the ignition relay shorts, burns out, or otherwise fails while the engine is operating it will cut off power to the fuel pump and ignition system.
Where is the fuel pump relay on a 2008 Ford f150?
The 2008 Ford F-150 fuel pump relay location is
in the fuse box
. To get to the fuse box look to the left of the steering wheel look for a small seam or crack along the dash. Using a screwdriver or prybar You will want to pop this open. On the inside, You will find a bunch of fuses.
Where is the fuel pump relay on a 2006 Ford f150?
The fuel pump relay in a 2006 Ford F-150 is located in
the main fuse panel under the hood
. The main fuse panel for the car can be found on the right side of the engine bay near the battery.
How do you change a fuel pump on a Ford f150?
- Lift Your Truck. …
- Siphon the Fuel Out of the Fuel Tank. …
- Remove the Heat Shield. …
- Place Two Floor Jacks Underneath the Fuel Tank. …
- Drop the Fuel Tank. …
- Disconnect the Fuel Pump Lines From the Fuel Pump Module. …
- Clean the Fuel Pump Module. …
- Remove the Old Fuel Pump Assembly.
How do I reset my fuel pump shut off switch?
- Locate your car’s inertial trigger or airbag control module. …
- Push the button on the inertial switch; it should be clearly marked as the fuel pump reset, and may be in a contrasting color to the case.
How do I reset my fuel pump?
Locate the reset button to the fuel pump shut off switch.
Press and hold the reset button for about 20 seconds
. Note: The fuel pump shut off switch reset button is usually located either under the dash in the driver compartment or under the driver or passenger seat.
How do I reset my fuel shut off switch?
- Turn the ignition switch OFF.
- Ensure that there is no fuel leaking in the engine compartment, along any of the lines or at the tank. …
- If no leakage and/or odor is apparent, reset the switch by pushing the reset button on the top of the switch.
