This should be in
the owner’s wallet card
which is usually kept in the glove compartment. If the owner’s manual is lost, you can find the factory code on the label of the Remote Anti-Theft (RAP) module.
Where is the remote anti theft rap module?
This RAP module is located
behind the left cargo trim panel
and is fairly easily accessed through a removable panel.
Where is the rap module located?
RAP System
On Expeditions and F-Series, the RAP module can be seen
under the driver’s side of the dash against the firewall
. Usually, the part number tag of the RAP module will also contain the five-digit code for the key pad on the door.
Where is the computer module located on a 2004 Ford Explorer?
The location of it in the 2004 Explorer is
behind the dashboard to the left of the radio
. You will need to remove the radio to access it.
Where is the rap module on a 2005 Ford Explorer?
On most 1999 to 2005 Explorers and Mountaineers, you can find the RAP module in
the compartment where the tire change jack is located
. Step 2: Locate the cover for the jack. The cover will be on the driver’s rear in the cargo area.
What is the factory-set code for Ford Explorer?
The obvious answer is to check Your
owner’s manual
. It will be in the wallet card, left in the glove boxBy the manufacturer. It is called the “factory default code” on the card. If You don’t have access to the manual, the code can be found on the Remote Anti-Theft Module, also referred to as the RAP.
What is perimeter anti-theft system?
The perimeter alarm is
a deterrent against unauthorized access to your vehicle through the doors and the hood
.
Where is the keyless entry code on a 2004 Ford Explorer?
Basically it’s like this: Pop off the Front Windshield Defroster Vent Cover. From the outside of the XLT look through the windshield at the Keyless Entry Module. The Factory Permanent Code is
printed on a sticker, on the top of the module
.
How do you reset the keyless entry on a 2004 Ford Explorer?
INSERT key into Ignition and TURN from OFF to RUN 8 times within 10 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm Programming Mode. Within
20 seconds press any button on first
keyless remote fob. Door locks will cycle to confirm programming.
How do you unlock a Ford Explorer with a code?
To unlock all doors,
enter the factory-set code or your personal code, then press 3•4 within five seconds
. To lock all doors, with the driver door closed, press and hold 7•8 and 9•0 at the same time. You do not need to enter the keypad code first.
Where is the PCM on a Ford Explorer?
Where is the PCM on a 2004 Ford Explorer? The PCM is located in
the rear of the Engine compartment on the passanger side
.
Where is the computer module on a 2000 Ford Explorer?
The RKE system module is located in
the jack compartment
. Open the jack compartment door and look toward the passenger door and you should see a sticker there with the code.
Where is the 5 digit factory-set code?
You can operate the keypad with the factory-set five-digit entry code. The code is
on the owner’s wallet card in the glove box
and is available from an authorized dealer.
How do you bypass the anti-theft system on a 1999 Ford Explorer?
First, go to the driver’s side of Your vehicle, and insert the key into the lock. Turn the lock to the right, or
to the unlock position. Hold this position and count for 25 to 40 seconds
. Doing this will bypass the anti-theft system.
How do you unlock a Ford Explorer without the key?
How do you unlock a Ford Explorer without the key? To open a ford explorer without keys
enter in the five-digit code in order on the keypad then press the 3-4 button within five seconds of entering your code
to unlock your doors.
