- Step 1 Tailgate Handle. …
- Pull off the panel and then pull cables inward, causing tailgate to release and go down. …
- Remove rubber pieces from cable and pull cable from insert. …
- 15% Off Cleaning Tools. …
- Use your 5/16th-in. …
- Push in black clip to let handle fall out. …
- Put new tailgate handle back in.
How do you open a tailgate with a broken handle tundra?
- Grab the tailgate latch handle and try pulling it to the open position. …
- Spray the lubricant into the handle mechanism. …
- Grab the screwdriver and move the side of the tailgate where it attaches to the truck side via the hinges. …
- Drop the tailgate down.
How do you fix a broken tailgate handle?
Push a new tailgate handle into the cavity from the front of the tailgate. Replace the two holding bolts and tighten with an adjustable wrench. Insert the latch rods back into the locking clips on each side of the tailgate handle. Rotate the clips clockwise until they lock into place.
How do you open a tailgate with a broken handle?
How much does it cost to replace a tailgate on a Toyota Tundra?
The average cost of a Toyota Tundra Tailgate replacement is
between $543 and $1300
. The labor costs are estimated between $243 and $400 while the parts are estimated between $300 and $900. It’s recommended that you get a personalized quote that is based on your location, the make, model and year of your car.
How do you change a tailgate handle on a 2010 Toyota Tundra?
How do you open a tailgate that won’t open?
How do you fix a tailgate latch on a Toyota?
How do you fix a tailgate that won’t latch?
How much does it cost to fix a tailgate handle?
Replacing a Tailgate Handle or Lock
If you only need to replace your tailgate handle, the cost is usually between
$117- 127
in most areas. This can vary by the make, model, and year of your truck. The cost of labor is usually around $40 for a simple job.
How does a tailgate latch work?
How it Works.
When the rods are pulled, the outside latch is retracted which releases the tailgate
. The rotating assembly has a straight bar and the rods are attached to both ends. When the bar rotates, it is easy to see how it pulls the rods.
How do you fix a bent tailgate?
How do you open a truck with a broken handle?
How do you unlock a Toyota tailgate?
How do you open a tailgate from the inside?
The tailgate can be locked from the inside using a button on the dashboard.
Press the button on the dashboard
. The tailgate will unlock and can be opened from the outside by pressing the rubberized pressure plate on the handle.
How do you change a tailgate handle on a 2007 Toyota Tundra?
How do you remove the tailgate on a 2008 Tundra?
Why is my liftgate not working?
The most common liftgate issues can be traced back to the
motor or motor start solenoid
. If you hear a clicking noise when the switch is activated, more than likely you have a bad solenoid. Using a small jumper cable, bypass the solenoid by putting direct power to the motor to see if it will run.
How do you realign a tailgate?
- Loosen both pickup box side hinge bolts (1) on the right and left side.
- Install shims (2) on both sides, if needed.
- Hand-tighten the bolts (1) on each side.
- Close the tailgate and adjust for fit and flushness, both up-down and fore-aft.
- Open the tailgate and tighten the bolts.
How do you open a tonneau cover when tailgate won’t open?
If the tailgate refuses to open, whatever the reason is, simply
open the truck bed manually
. To do so, unhook the latches and lift the cover. Then replace the handle, re-install the entire tonneau cover and latches. The only problem with this process is that it is time-consuming and a bit strenuous too.
