The SPT short shifter replaces the entire linkage, most aftermarket units replace the shifter piece only. It should take
a few hours at a minimum
. I would definately question the dealer about the trunk tray install though. That should only take five minutes tops.
Is it easy to install a short shifter?
No,
it is actually easy to install a short shifter
, plenty of newbies have done it. It just gets easier with experience! Below, are step-by-step manual instructions on how to install a short shifter.
Do short shifters really make a difference?
One expert estimated that in his experience short throw shifters
could reduce the distance between throws by up to 70%
. Obviously, that’s a significant difference and will vary considerably based on your car’s stock shifter as well as your choice of replacement. Shorter throws improve both performance and safety.
Are short shifters hard to shift?
Unfortunately,
greater shift effort
is a side effect of a shorter shifter, as you have less leverage, due to less distance from the fulcrum (AKA shifter ball) to the top of the rod, AKA shift knob.
How much do short shifters Cost?
A short shifter can cost anywhere from
$30 – $150 USD
with all the bits and pieces needed to be installed in your car.
What is double clutching and Granny shifting?
Granny shifting is shifting at very low rpm, driving slowly, like a stereotypical granny would. Double clutching is
a technique used for rev-matching in downshifts
. It is useful for older cars, with not very good synchros.
Is short shifting bad?
The good news is that
short shifting isn’t bad for your car
and shouldn’t hurt anything as long as you’re doing it correctly. Shifting too early will obviously stall out your car which is bad, but upshifting at 2,500 RPM instead of 3,000 isn’t going to hurt your transmission, gearbox, or clutch.
Will short throw shifter void warranty?
Unless you bent a fork or something… but they can’t deny you for warranty without having a resonable cause… and pinning a short shifter on anything is next to impossible.
What is a quick shifter car?
A quickshifter (or quick shifter) is
a device that allows clutchless shifting on a manual transmission
, and is commonly found on motorcycles. It can increase the safety and comfort of the vehicle since it eliminates the need to use the clutch or throttle before and after a gearshift.
How do you install a short shifter?
If you’re looking into ways to upgrade your car on a limited budget, then short shift kits are a popular mod to look into. They’re reasonably inexpensive and
fairly simple to install
, so here’s what you need to know…
How do I know if I have a short throw shifter?
If you can shift without moving ur elbow
, then you have a short shifter. If you have to move your elbow, then you don’t.
What is a short shift gearbox?
A Short Shifter is
a linkage mechanism on the gearbox which shortens the gear throw
. This is the shift distance to cover when shifting from one gear to the next gear. … Such shortened sticks (like you can find plenty on the internet) are not an actual short shifter, but just a lower gear stick).
Is Double clutching easy?
Double clutching is
not a complicated process
. However, new truck drivers are often intimidated it because it can be difficult to shift smoothly.
Does Double clutching hurt your transmission?
This technique, sometimes called “jake shifting”, requires high skill and much practice shifting without the clutch, and is usually not recommended among truck drivers because
mistakes can cause damage to the transmission
.
Is it OK to shift without using the clutch?
Shifting your car without using the
clutch isn’t necessarily bad for it if it’s done properly
. However, you shouldn’t expect smooth shifts like you get when actually using the clutch pedal. Therefore, if you try this in your car, then you might hear some grinding until you do it correctly.
