How Do You Fix A Throttle Actuator Control System Stuck Open?

by | Last updated on January 24, 2024

, , , ,
  1. Replace the TPS. Commonly this will require the throttle body to be replaced as the TPS and the throttle body is an integrated unit.
  2. Clean the throttle body.
  3. Replace the throttle body.
  4. Replacing the PCM. (
  5. Repair the wiring.

How do I fix error code P2112?

  1. Repairing or replacing wiring harness as needed.
  2. Replacing faulty throttle position sensor.
  3. Replacing throttle body actuator.
  4. Fixing a poor electrical connection point.
  5. Unsticking the throttle body plate.

What does engine code P2111 mean?

The error code P2111 usually refers to the

throttle actuator control system which is stuck open

. Depending on the driver’s request for power, the throttle motor will open and close the throttle plate by allowing more or less air to pass through the engine. The engine computer controls the throttle motor.

How do you fix throttle actuator control system forced limited power?

The most common fix for this code is replacing the Throttle Actuator Control. Other common repairs include:

Repair of the coolant leak

, replacement or refilling the engine coolant. Cleaning or replacement of the ABS sensor.

What are the symptoms of a bad throttle actuator control module?

  • Throttle hesitation. Most of the time, the engine responds to throttle pressure applied by the driver without stumbling or hesitation. …
  • Poor fuel economy. …
  • Engine stalling often.

How much does it cost to replace a throttle actuator control system?

The average cost for a Throttle Body Replacement is

between $489 and $593

but can vary from car to car.

How much does a throttle actuator cost?

To replace your car’s throttle body, you will pay as little as $370 or

as much as $1,500

. Labor should be between $70 and $260, and parts should cost you from $110 to $600.

Where is the throttle actuator control?

The throttle controller is located

on top of the engine between the air intake and the intake manifold

.

What does code 2106 mean?

Code P2106 is an indication that the ECM is

in failure management mode

and has limited power to the throttle control actuator system.

What code is P2138?

The P2138 trouble code indicates that the

Engine Control Module has detected a malfunction within the D and/or E circuits of the throttle position sensor

.

What causes an electronic throttle control to go bad?

In this case, the problem may be caused by

a miscommunication link from the throttle controller and the engine’s air fuel mixture

which is regulated by the mass air flow sensor on many cars. … In most cases, issues with the throttle controller are electric, either caused by a damaged sensor or electrical relay.

How do I reset my electronic throttle control?

Resetting your electronic throttle control manually can be a tricky job. First, make sure the accelerator pedal is fully released. Next,

turn the ignition on and then turn it off and wait for ten seconds

. During these ten seconds, be sure the throttle valve is moving by listening for a sound of operation.

Can you drive with a messed up throttle body?

Can you drive with a bad throttle position sensor? It is not a good idea to drive with a bad throttle position sensor. Driving your car in this

condition can be dangerous

because your car might not accelerate properly or could suddenly accelerate without the driver pressing the gas pedal.

Can I drive with the throttle control warning light on?

If any of the lights are flashing, it’s alright –

as long as they turn off after a few seconds

. At this point, your vehicle is running a system check, and everything is perfectly normal.

Can you repair throttle body?

Once the problem is identified, then a new throttle body will need to be

installed on the air intake

system to fix the problem. While some automotive repair shops will allow you to bring in one you’ve purchased at another retailer, HomeTowne does not install outside parts on cars.

Charlene Dyck
Author
Charlene Dyck
Charlene is a software developer and technology expert with a degree in computer science. She has worked for major tech companies and has a keen understanding of how computers and electronics work. Sarah is also an advocate for digital privacy and security.