To add transmission fluid to the 2004 Ford Explorer park the car on an even surface and pop the hood. Locate
the transmission
and look for the dipstick sticking out, it will have a round o ring on the end. Pull it out and wipe it clean, then stick it back in and see were it is on the fill level.
How do you add transmission fluid?
- Park your car on a level surface with the engine running. …
- Raise the hood. …
- Find the automatic transmission fluid pipe. …
- Pull out the transmission fluid dipstick. …
- Check the condition of the transmission fluid. …
- Add transmission fluid, if necessary. …
- Run the car and take it through each gear if possible.
Where is the transmission fluid on a Ford Explorer?
In order to check the transmission fluid on a ford explorer, you must
remove the cap and dipstick located at the front of the engine bay
, while the engine is running, and then reinsert and remove the dipstick to measure fluid level and viscosity.
How do you put transmission fluid in a 2005 Ford Explorer?
The 2005 Ford Explorer has a maintenance free transmission and does not have a dipstick. To check the transmission fluid level You will have to
go and locate the check valve on the oil pan
. If You run into any problems You will have to take it to a service mechanic to be inspected.
Where do you put transmission fluid in a Ford?
Insert the tip of the transmission funnel into the tube
. Add half a quart of transmission fluid. Wait a moment to allow the transmission fluid to drain down the tube, then repeat step 3. Repeat until the dipstick is continuously covered with transmission fluid up to the middle hole.
What are the symptoms of low transmission fluid?
- Noises. If your transmission is working properly, you shouldn’t hear any noise while you’re driving as it should transition smoothly. …
- Burning Smell. Any foul smell coming from your car should direct you to your nearest service center. …
- Transmission Leaks. …
- Slipping Gears.
How do you check transmission fluid on a ford?
- Insert dipstick fully and pull out to check fluid level.
- Transmission fluid expands when warmed up (driving for 20-30 minutes) Transmission level should be between the “HOT” marks.
- If the vehicle is cold the level will be between the “COOL” marks.
How do you check transmission fluid in a 2005 Ford Explorer?
The 2005 Ford Explorer has a maintenance free transmission and does not have a dipstick. To check the transmission fluid level You will have to
go and locate the check valve on the oil pan
. If You run into any problems You will have to take it to a service mechanic to be inspected.
How do I check transmission fluid in a 2004 Ford Explorer?
Pop the hood to Your engine using the hood-release lever under Your dash panel near the steering wheel. You can then locate the
transmission dipstick in the engine
. Pull that straight up and wipe it off with a rag. Stick it back in the tube and pull it out again.
How do you change a transmission filter on a 2004 Ford Explorer?
Motorcraft
Automatic Transmission Filter
Kit – for 2004 Ford Explorer.
How do you check transmission fluid without dipstick?
Automatic transmissions which
use World Standard (WS) fluid are sealed and do not consume fluid
. This eliminates the need for periodic fluid checking using a dipstick.
How do you put transmission fluid in a sealed transmission?
A sealed transmission
does need to have the fluid checked or replaced periodically
. … Auto techs can check the fluid of a sealed transmission through an access in the side of the transmission. Some may opt to remove the transmission pan to completely replace the transmission fluid, as well as the gasket.
Is there a warning light for low transmission fluid?
Warning Lights: You will see a
dashboard warning light indicating that your transmission fluid temperature is hotter than normal
. … Puddles: If you are noticing puddles forming under your car of red liquid then this is most likely a transmission fluid leak.
Can I just add transmission fluid?
Usually, you should not have to add transmission fluid
. If the level is down significantly below the “Add” or “Cold” line, you probably have a system leak and should take the car to your mechanic to have your car inspected for leaks by a technician.
How do I know if I need to add transmission fluid?
- Noises. If your transmission is working properly, you shouldn’t hear any noise while you’re driving as it should transition smoothly. …
- Burning Smell. Any foul smell coming from your car should direct you to your nearest service center. …
- Transmission Leaks. …
- Slipping Gears.
