Common solutions for: Roper Washer won't spin or agitate.
Inspect the drive belt to determine if it is broken or if it is loose on the pulleys
. If the drive belt is broken or loose, replace it. The motor coupling connects the motor to the washer transmission.
Why did my Roper washing machine stop working?
Common solutions for: Roper Washer stops mid cycle
If the door lock is defective
, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage. If the door lock is damaged or does not latch properly, replace it.
How do you disassemble a roper washing machine?
How do you reset a roper washing machine?
Why will my washer not fill up with water?
How do you bypass the lid lock on a Roper washing machine?
Why is my Roper washer stuck on wash?
If your Roper washer seems stuck on a cycle,
check that the top of the drain hose is higher than the water level in the washer
. If it's not, the washer won't operate properly. Do not seal the drain hose because it needs air for water to drain properly.
How do I fix my agitator?
How do I reset my Roper Whirlpool washer?
Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds
. When you turn it back on it should be reset.
How do you fix the agitator on a Roper washing machine?
How do I remove the agitator from my Roper washing machine?
Where is the filter located on a Roper washing machine?
Most newer washing machines come with a reset feature that allows you to restart the washer after it experiences an error code or fault. Causes that lead to these problems include power spikes, imbalanced loads or an interruption in power.
Some machines have a button you push to reset its motor
.
What are common problems with washing machines?
- Vibrating Washer.
- Leaky Washer.
- Noisy Washer.
- Washer Won't Run.
- Washer Won't Drain.
- Detergent Won't Dispense.
- Smelly Washer.
How do I get my washing machine to fill with water?
Will washer work without lid lock?
NO. The lid lock it to prevent injury to the people near the washer, as without it stopping the machine, the agitator will turn with the lid open
. So. If you will open the top up, you should see the lid switch, and you should see the electric wires attached to it.
Why is my lid lock flashing?
The Lid Lock Light will flash
if Lid Lock has not moved into the Lock Position, the Lock Motor can not be powered, or the Lid is not closed completely due to interference
. Some models will lock immediately, while others will not lock until after the wash cycle has started.
Why is my washer lid locked?
If the door or lid won't open at the end of the cycle, then
the lock mechanism may be at fault
. Most washers will have a manual release to unlock the mechanism and allow you to open the door or lid. The release is normally accessible from below the door lock, or on some models, from inside the soap dispenser housing.
How do I know if my washing machine agitator is broken?
The agitator should start to oscillate back and forth, mixing up the clothes in the water.
If the agitator does not move, double check that the sensor is depressed. If it still does not move with the sensor depressed, the agitator is broken and should be repaired
.
Why won't my washing machine agitate or spin?
Why does my washer spin but not agitate?
There is a chance that a
faulty drive motor
is the culprit when the washer won't agitate but spins. The motor drives the transmission that causes the agitator to oscillate. Diagnosing a defective drive motor is difficult and should be done by a technician.
