What Is The Best Siding Nailer? - Fixanswer

What size nails do you use for siding? The most common size is from

11⁄2 to 21⁄2 inches long

, with a diameter of either 0.080-inch or 0.092-inch and a minimum head of 3⁄8 inch. Siding and additional materials have an impact, so you should check the requirements of each job before ordering your nails.

Are Freeman siding nailers any good?

It shoots nails just as well as the Makita, Hitachi, and Dewalt siding nailers I have used. From fiber cement to hardwood. The results are

great

– most of the time. … This gun will double fire when you are are driving a lot of nails and your compressor does not have enough air to keep up with the demand.

Can I use a brad nailer for siding?

A pneumatic nail gun should be used for siding installation, especially for harder fiber cement siding. …

You cannot use a brad gun for installing siding

because the brads leave two holes for each brad and do not hold up as well as siding nails.

Can you use a nail gun for siding?

The answer is,

yes

. Framing nail guns can be used for siding installation, if the nail being used is long enough to attach the siding firmly to your exterior wood sheathing. … You may also find that siding nailers are a few pounds lighter than framing guns.

What's the difference between a siding nailer and a roofing nailer?

Both tools are coil nailers that are built to drive nails into wood, but you can't use them interchangeably. …

Siding nailers are for installing siding and roofing nailers are meant for installing roofing

.

What is special about a siding nailer?

Nails Used

A siding nailer uses

shorter nails —

typically 1 1/4 to 2 1/2 inches, often with wider heads. Some siding nailers are designed for use with aluminum nails which work better with aluminum siding.

Can I use framing nailer for trim?

Just as you wouldn't use scissors to trim a hedge, you shouldn't use a framing nailer to finish fine, detailed jobs. You use

framing nailers for bigger jobs

, such as construction, carpentry, and decking. On the other hand, finishing nailers are best for detail jobs that are often found around doors and windows.

Can you use a siding nailer for vinyl siding?

Vinyl siding can either be nailed by hand—with a hammer—or by

a power nailer

.

What size nails do you use for cedar siding?

Siding Type Thickness (in.) Nail Size	Bevel 3/4 2-1/4 (7d)	7/8 & greater 3 (10d)	Boards, Tongue & Groove, and Channel 5/8 2 (6d)	3/4 2 (6d)

Can you brad nail Hardie siding?

James Hardie products can be hand nailed or fastened with

a pneumatic tool

. Pneumatic fastening is highly recommended. Set air pressure so that the fastener is driven snug with the surface of the trim.

Will a brad nailer go through Hardie board?

Overall,

only two types of power nailers work best

for attaching hardie siding: siding and roofing nailers. But if you must use a framing nailer, to install any James Hardie product, be sure to fit it with a quality flush mount attachment so as to control the depth the fastener is driven.

Can I use a roofing nailer for Hardie siding?

You can shoot Hardie siding on with air powered nailers or use

hand driven roofing nails

to attach siding to the home or structure. The nails can be ringed- shanked or smooth just make sure you are hitting the studs in the wall. … Our Crews prefer 1 3/4 “ smooth shank roofing nails for Hardie installation.