Yes, they bolt right in
. Better if your th350 is a longtail (truck) tranny. That way you wont need another driveshaft.
Will a 700R4 bolt up to a SBC?
yea the problem is the 700r4 from your 2.8
will not bolt up to a small block
because its got the wrong pattern, if you get one from a 4.3 however it will bolt right on.
What engines are compatible with a 700R4 transmission?
| MODEL ENGINE | CAPRICE 3.8L / 5.0L | CAMARO 2.8L / 5.0L | SUBURBAN 6.2L | S10 PICKUP 2.5L / 2.8L |
|---|
Will a 700R4 work without a computer?
There are
no TV cable
, mechanical speedometer drive, or governor provisions. … To run a 700-R4 trans behind a carbureted engine without a computer, at the very least the TV cable must be hooked up to the carburetor and properly adjusted.
Is a TH350 stronger than a 700R4?
According to the big trans guys they
are actually stronger than the 700
; smaller, lighter, and a better 1st gear ratio. I have had a mildly built 200-4R behind a 462 in a 4000# car for over 10 years with no issues.
Is a 700R4 the same length as a Turbo 350?
Length And Weight
The TH350's case length is 21 5/8 inches. Depending on the tail shaft housing, its overall length can either be 27 5/8 or 30 5/8 inches. The 700R4's
case length is 23
3/8 inches and its overall length is 30 3/8 inches. The TH350 weighs 120 lbs., while the 700R4 weighs 155 lbs.
Is a 700R4 the same length as a Turbo 400?
Registered. edit: okay, AA sez the 350 is 21.5′′, 700r is 23.375′′, 4l60e is 21.875′′, and
400 is 24.25′′
.
How much HP can a 700R4 handle?
The Street/Strip 700R4 is good for
about 550 hp maximum
, but with the HD input drum it is good for about 625 hp max. Add another $240.00 for the input drum.
Will a 5.3 LS bolt to a 700R4?
thanks! Re: 5.3 mated to a 700r4?
It will bolt up
, but with only 5 bolts on the bell housing. If I remember right you will need a special flywheel, several companies make them like TCI.
What years did Chevy use the 700R4 transmission?
| Gear Ratio | R 2.29:1 |
|---|
Which is better 200r4 or 700R4?
There is also the longer nature of the 700R4 which requires certain modifications in order to cross member and driveshaft. Conversely,
the 200-4R can be made to be stronger than the 700R4
. It is, however, worthy to note that the 200-4R is popularly known as the weaker of the 200-4R/700R4 pair.
How do I know if my 700R4 is locked up?
To tell if the converter is locking up in the early GMs try this- Once at interstate cruising speed(no load other than cruising) ,
very lightly touch the brakes with your LEFT foot
, while maintaining your current speed and accelerator position.
Is a 700R4 good for drag racing?
Racing with a stock 700R4 while in overdrive risks the integrity of the O/D band and limits your performance in a drag race, and can ruin the transmission. But a custom built 700R4 is made of sterner stuff, and reduces the lag time introduced by sloppy and sluggish shifts.
Can you swap a 700R4 with a TH350?
This swap is possible, most go the other way TH350 to 700R4. Driveshaft length needs to be adjusted. Shift linkage will need to be corrected, I recommend getting an aftermarket floorshifter it makes the swap easier.
How much power can a stock Turbo 350 handle?
The Stage 1 TH350 is rated up to
450 hp
.
Is a 4L60 the same as a 700R4?
In 1990, GM decided to code and renamed their transmissions, the 700R4 is best described as a 4 speed, longitude transmission rated for vehicles around 6000 lbs. It was this information that was used to change its name to 4L60; therefore,
a 700R4 and 4L60 are the same transmission.
