Why Does My Heating Come On When I Put The Hot Water On?

by | Last updated on January 24, 2024

, , , ,

A frequent and likely cause is

a faulty or jammed three port valve

. In a typical central heating and boiler system, the valve sends water to either the radiators, the hot water cylinder, or both. … In the list of possible repair costs for a heating system, your problem is a fairly economical one to rectify.

Should my radiators come on with hot water?

In order for all radiators to get hot,

the central heating pump must be activated

, and this is usually controlled by the programmer. If only one radiator was getting hot, it could have just been the boiler ‘dumping' excess heat for a couple of minutes once the domestic hot water reached the required temperature.

Why is my boiler turning on when the heat is off?

If your boiler is turning itself off and on again every few minutes then we are looking at a potential issue called

‘short-cycling'

. Not to be confused with cycling shorts, which are comfortable and practical, short-cycling is bad for your boiler and bad for you as it will increase your heating bills.

Does hot water come on with heating?

If you have a combi boiler and your radiators come on when you open the hot taps. … This valve controls whether the boiler heats hot water for the taps or the radiators. Other indications of a faulty diverter valve may include: No hot water when you open a hot tap, but the

central heating works normally

.

Why is my heating coming on by itself?

Most heating systems are setup to automatically turn on and off based

upon the setting of a thermostat

. When heat is required (i.e. thermostat reading lower than setting) then the heat system will come on till the thermostat reads a new temperature higher than the setting.

Why am I getting heating but no hot water?

If your heating is working normally but your hot water is not hot from your taps or shower,

there could be a problem with your diverter valve

. … If you have a faulty or stuck diverter valve, your hot water may not work. One of our heating engineers can resolve this problem for you if you give us a call.

Why do my radiators get hot when the central heating is turned off?

The diverter goes into a ‘mid position', which allows the hot water to flow to both the water tank and the radiators. When a

diverter fails or gets blocked with debris

, hot water intended for the hot water circuit can get into the radiator circuit. Then the radiators will be hot even though the heat is turned off.

Why does my heating come on in the middle of the night?

It is not advisable to set the standby temperature too high this will result in the boiler coming on regularly 24 hours a day to maintain a constant high temperature and this will be more prominent at night when the genera ambient temperature falls. …

How do I know if there is air in my boiler?

If you're experiencing cold radiators or taps that won't release any water, your central heating or hot water system could have an airlock. These are the two most common signs, however you may also be able to

hear tapping or banging sounds

and your boiler pressure may be on the low side.

Is it bad to have the heating on all night?


Do not ever leave the heater unattended

. Avoid the carbon monoxide poisoning by turning off the heater and unplugging it before leaving the room or going to the bed. Signs of too much carbon monoxide in the rooms include headache, dizziness, abdominal pain, discomfort, vomiting, nausea and weakness.

Can heating work without hot water?

A relatively common fault with boilers sees the

central heating work with no hot water

. In some cases – such as with broken diverter valves – the hot water will only work when the central heating is fired up, whereas in other cases, the hot water will not work at all.

Why does my central heating system turn on and off?

When a furnace keeps turning on and off, it is usually

due to short cycling

. This is the term used to describe problems originating from within the heating system. If short cycling is not promptly diagnosed and corrected, it could cause permanent damage to your heating unit and higher utility bills.

How do I know if my diverter valve is faulty?

  1. Taps not getting hot water. The most common symptom of a faulty diverter valve is when you don't get any hot water to your taps and showerheads. …
  2. Lots of hot water, but no heating. …
  3. You have hot water only if the heating is on.

Why does my hot water keep going cold?

If you've noticed that your hot water is suddenly turning cold after a very short amount of time, the most likely cause is

a broken dip tube inside your hot water heater

. … And when that happens, you'll get lukewarm water delivered to you soon after you start using hot water.

Should one radiator always be on with central heating?

However, while TRVs can, technically, be installed on all radiators, it's usually a good idea to leave one radiator without a TRV and permanently switched on. Ideally, this should either be a

bathroom

, which would usually benefit from permanent heat, or the room with the thermostat in it.

David Martineau
Author
David Martineau
David is an interior designer and home improvement expert. With a degree in architecture, David has worked on various renovation projects and has written for several home and garden publications. David's expertise in decorating, renovation, and repair will help you create your dream home.