Why Does My Jeep Commander Say Perform Service?

Why does my car says perform service? All this is is a

feature that tells you when to change your oil, instead of relying

on the trip odometer or service stickers. Changing the oil will not reset it. you have to do that manually every time you change the oil.

What does it mean when it says perform service on a Jeep Commander?

Why does my car says perform service? All this is is a

feature that tells you when to change your oil, instead of relying

on the trip odometer or service stickers. Changing the oil will not reset it. you have to do that manually every time you change the oil.

What does perform service mean on 2007 Jeep Commander?

#5 · Apr 22, 2007. Re: “perform Service” when it says “perform service”,

you press and hold the reset button until it resets

. In the menu options, set it for the interval you want to be reminded to get an oil change. I dont think you can turn off the option though.

How do I get rid of Jeep perform service?

1. Turn on the engine.
2. On the vehicle’s dash, press the “Step” button until “Miles to Service” is displayed.
3. Press and hold the “Reset” button, near the “Step” button, until the “Miles to Service” flashes and resets. Verify the “Perform Service” light goes away.

How do you reset the service light on a Jeep Commander?

Gently press the

gas pedal all the way down to the floor three times within ten seconds

. (With each press you will see various warning lights disappear within the dashboard, including the oil warning light). Press the “Start/Stop” button once to turn the electronics off.

How do you reset the perform service on a 2007 Jeep Commander?

Instructions: 1-Turn the ignition to RUN (second position) 2-Press the accelerator pedal all the way down slowly three times within 10 seconds. 3-

Turn ignition OFF then turn the ignition to RUN again

to verify the maintenance has been reset.

What does perform service mean on a 2006 Jeep Grand Cherokee?

Needs to perform the

manufacturer’s suggested maintenance service

. It could be as simple as an oil and filter change – based on mileage and previous maintenance records. After the service the repair shop will reset the warning light.

How do I reset my Jeep computer?

1. Step 1 – Remove the positive (red) battery cable.
2. Step 2 – Ground the red cable to the negative terminal.
3. Step 3 – Reconnect the positive battery cable.
4. Step 4 – Turn on your Jeep.
5. Step 5 – Cycle the headlights.
6. Step 6 – Turn the key off and remove.

How do you reset the service indicator on a Jeep 4wd?

1. Turn the ignition switch to the “ON” position without starting the vehicle.
2. Press the gas pedal to the floor slowly three times within 10 seconds.
3. Turn the ignition off. Wait 10 seconds and start the engine.

How do you reset the dash on a Jeep?

1. Turn the ignition switch to the “ON” position without starting the vehicle.
2. Press the gas pedal to the floor slowly three times within 10 seconds. Turn the ignition off. Wait 10 seconds and start the engine.

How do you reset the service light on a 2006 Jeep Commander?

1. Stop the vehicle and turn the ignition switch to the RUN position without starting the engine. …
2. Fully depress the GAS PEDAL slowly three times within 10 seconds. …
3. Turn the ignition off and start the engine to verify the indicator has been reset.