What Is The Normal Socket Size?

Typically, the most commonly used types are

10mm sockets and 36mm sockets

.

What is the size chart for sockets?

How do you measure socket size?

1. Turn on the digital caliper and set it to read in inches, not millimeters. …
2. Close the caliper jaws until each jaw rests on one flat side of the nut on opposite sides.
3. Check the caliper display. …
4. Turn on the digital caliper and set it to read in millimeters, not inches.

What are the 4 socket drive sizes?

These drive fittings come in four common sizes:

1⁄4 inch, 3⁄8 inch, 1⁄2 inch, and 3⁄4 inch

(referred to as “drives”, as in ” 3⁄8 drive”).

What’s the next size smaller than 1/2 inch?

What is equivalent to a 15 mm socket?

What are the standard wrench sizes?

Wrenches: Standard Combination Wrenches (

1/4, 5/16, 11/32, 3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4, 13/16, 7/8, 15/16, 1

) Metric Combination Wrenches (6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19) Standard Flare Nut Wrenches (3/8, 7/16, 1/2, 9/16, 5/8, 11/16, 3/4, 7/8) Note: Each wrench may combine two sizes.

Are 6 or 12-point sockets better?

Answer: It’s true that

12-point sockets are fine for most lightweight repairs

, but heavy wrenching calls for a six-point socket. A six-point socket is much less likely to slip off a stubborn fastener or round over the corners. Here’s why: (1) Six-point sockets have thicker walls, so they’re less likely to flew.

What are the most common wrench sizes?

Most common are the

1/4-inch, 3/8-inch and 1⁄2-inch ratchet

drivers, but 3⁄4-inch and 1-inch sets are available for heavy-duty work.

What is a 72 tooth ratchet?

Low-tooth ratchets generally range from about 20 teeth to as high as 40 teeth. That means you’ll see about an 18-degree swing arc to a 9-degree arc from coarse or low-tooth-count ratchets. … Fine, or high

-tooth-count

, ratchets range from about 72 teeth to 160 teeth.

Is 5mm the same as 1/4 inch?

5mm = just over 3/16 inch

.

6mm = almost

1/4 inch. 7mm = almost 9/32 inch (= a bit over 1/4 inch) … 11mm = almost 7/16 inch.

Is a 3/8 socket the same as a 10mm?

So what is a

10mm

socket equivalent? The equivalent imperial size of a 10mm socket is a 3/8 socket. Imperial sizes are known as SAE (Society of Automotive Engineers) or Standard.

How many inches is equal to 7 mm?

What’s equivalent to a 30 mm socket?

How many mm means 1 inch?

How many millimeters in an inch? 1 inch is equal to

25.4 millimeters

, which is the conversion factor from inches to millimeters.