The pink wire is
the CAR SPEED SIGNAL INPUT
. This is an optional wire and is not required to be connected. You can connect it to the speed pulse wiring circuit, if your car has one. There is no red wire on the harness.
Where do you connect the pink wire?
The white wire should be connected to the white wire. If you want the wall switch to turn off the light/fan, you need to hook the pink wire
in the box to the black wire on the controller
. You can prevent the switch from turning off the light by connecting black to black.
What is the pink wire?
At your ceiling box you have: – a black wire, this is most likely a “hot” wire (you can confirm with an electrical tester) – a pink wire, this is
most likely the “switched hot” from your wall box that can be turned on or off with a switch installed in the wall box
. – a white wire, this is most likely the neutral wire.
What color wires go together in a car stereo?
The
right-front speaker wires are gray
, left-front speakers are white, right-rear speakers are purple, and left-rear speakers are green. Ground wires are black, antenna wires are blue, and amplifier wires are blue with a white stripe.
What is the VSS wire?
In addition to the standard power and ground leads, remote-mount navigation (and even some in-dash units) systems connect to a vehicle’s Vehicle Speed Sensor (VSS) wire. Your vehicle’s cruise control uses the VSS wire
to determine the vehicle’s speed
— it serves the same function for the navigation system.
Where do you connect the illumination wire?
- Disconnect the negative battery terminal under the hood, using the socket wrench and the correct insert.
- Locate the orange wire leading from the back of the stereo’s wire harness.
What is reverse wire on radio?
When the
radio detects the backup light is on by voltage
, the radio switches into reverse camera input mode automatically. Some of the reverse cameras’ video cable attached ( Refer to under picture ) with a trigger wire to extend the Reverse camera detecting lead to the positive terminal of backup light.
Which color wires go together?
| Function | Protective ground | label | PG | Color, common | bare, green , or green-yellow | Color, alternative | green |
|---|
What are the color codes for electrical wires?
- Phase 1 – Black.
- Phase 2 – Red.
- Phase 3 – Blue.
- Neutral – White.
- Ground – Green, Green with Yellow Stripe, or Bare Wire.
Is white or pink positive?
A pink switch would be positive when the circuit is closed
. White or gray neutral conductors are used in the commercial sector. A pink car would be a good thing. The wires are usually black.
Where do you connect the yellow wire on a car stereo?
The yellow wire is the
12 volt battery wire
, which should also be attached to the stereo for power. The final wire, the black wire, is the ground wire. This wire, once attached to the stereo, will help ground it.
What color is the memory wire on a radio?
When you find one that shows approximately 12V, you have found the constant 12V wire, also known as the memory wire. It’s
yellow
in most aftermarket head units.
What is a VSS harness?
This
vehicle speed sensor harness
is designed to be installed in conjunction with the GM® navigation radio. This harness allows the vehicle to track properly with the GPS system. It also features a video RCA input which can be used for an aftermarket rear camera.
What is the VSS sensor?
Vehicle Speed Sensors
The vehicle speed sensor (VSS)
measures transmission/transaxle output or wheel speed
. The ECM uses this information to modify engine functions such as ignition timing, air/fuel ratio, transmission shift points, and to initiate diagnostic routines.
