Can you add another collar to PetSafe wireless? It’s as simple as
purchasing an additional (compatible) receiver collar for each pet
. You can purchase additional receiver collars online or contact our Customer Care Centre.
How do I connect another PetSafe collar?
Turn the collar off prior to pairing. Confirm it is turned off by checking that the light is not flashing. Press and hold the power button on your second collar for five seconds. The light will turn solid green, then begin to flash and beep.
How do you put a collar on PetSafe Wireless stay and play?
Set Up Your Collar
Press and hold the button until the light flashes red
. The number of flashes on the collar indicates the current collar level. Press again quickly to increase the collar level. To set lower levels, continue through all the levels until you see one flash indicating level 1.
Why is PetSafe collar blinking red?
Why is my Invisible Fence collar blinking red? If you have started to see a red flashing light on your pet’s Computer Collar unit,
your Power Cap battery may need to be replaced
. You can order replacement batteries online, from your local dealer, or by calling 1-800-824-3647.
How do I pair my pet trainer collar?
How do I pair my pet trainer collar and remote?
How do you pair a dog collar with a remote?
Why is my PetSafe collar beeping but not shocking?
Touch both points on the collar while it is ticking or beeping. If you do not feel a shock, then
there may be a problem with the receiver collar
. Make sure you touch both points on the receiver at the same time when you hear the collar beeping. It will tell you definitively that the fence is or is not working.
How do I know if my PetSafe collar is on?
Hold the collar probes against the wire on the test light tool
. The collar will test all 15 stimulation levels, causing the tool to flash at each level. Important: The test light tool will have a dim flash when testing low levels. If a flash is not seen, hold the tool on the collar until higher levels are being tested.
Why is my PetSafe collar not working?
If Receiver Collar does not beep and the Test Light does not flash,
replace the 10. battery in the Receiver Collar
. If it still does not beep and the Test Light does not flash, contact the Customer Care Center at 1-800-732-2677. If the Receiver Collar beeps, there may be a complete or partial break in the 11.
How do I sync my PetSafe shock collar?
Use the Dog 1/2 button on the remote to select either Dog 1 or Dog 2. With the remote turned on and the collar turned off, press and hold the on/off button on the collar. 2. After about 5 seconds the LED on collar will turn off indicating that it is ready for pairing.
How do you use a PetSafe bark collar?
How long do petsafe wireless collars last?
The Wireless Containment System unit can last
up to approximately 10 years or more
if used properly. Batteries on the collar can last and be replaced up to 1 to 2 months.
