The CAMO DRIVE tool and hidden deck clips work with the top grooved composite, capped composite, and PVC deck boards, including Trex®, TimberTech®, AZEK®, Deckorators®, Fiberon, MoistureShield®, and more.
Can you use camo screws on composite decking?
Camo fasteners work with Composite, Cedar, Treated, PVC and Hardwood decking. The CAMO 1-7/8 inch Fasteners are compatible with
5/4′′ decking
.
Do camo starter clips work with Trex?
CAMO STARTER Clips
Not only are LEVER and DRIVE covered, but CAMO Clips
are warranted for use in leading grooved deck boards
, including Trex®, TimberTech®, AZEK®, Fiberon®, Deckorators®, and more. That means you can confidently use CAMO on every install.
What should you not use on Trex decking?
Cleaning solutions containing solvents can damage a Trex deck — notably
acetone or toluene-based solvents
. This is because they dissolve the decking. Oil and grease can also affect your deck, so remove these as soon as possible using warm soapy water and a soft-bristle brush if they come in contact with the decking.
What paint do you use on Trex?
Stains tend to work better than paints, but they might not last as long, she said — as is true for coatings on wooden decks. She said standard brands,
such as Behr and Valspar
, work well.
How many Trex starter clips do I need?
You will need
0.75 clips for every lineal foot of decking
. For example, 40 feet of decking would require 30 start clips. NOTE: When using hidden fasteners (both start and connector clips), one must be used on every joist.
How many starter clips do I need for composite decking?
Starter Clips: You will need
12 starter clips
to run on the first board. If you have over 50 decking boards, we recommend doubling the amount of starter clips and so on. Angle Brackets: If you are using composite joists, please see below.
How do you hide the Trex grooved edge?
Install Fascia Boards
Installing fascia boards is a common practice to hide the ends of composite decking boards. Like picture framing, it gives the deck a stylish and sleek look while hiding the exposed ends. The difference is, you will install it on the sides, directly over the edges and the rim joists.
What are the disadvantages of composite decking?
- A pricey alternative to wood. Durability comes at a cost, as composite decking is more expensive than wood. …
- Composites aren’t natural. …
- Composite decks aren’t completely maintenance free. …
- You’ll need to comparison shop.
Can you pressure wash Trex deck?
Trex high-performance decking (Trex Transcend, Trex Enhance and Trex Select) can be power washed. Use only a fan tip and up to a
3100 psi power washer
to remove dirt and debris.
How long does a Trex deck last?
Composite decking can last
over 20 years
with the proper care and maintenance. Composite holds up better under hot or cold weather shifts. Composite is resistant to rot, mold, and termites, which can take their toll on wood decking materials.
Is Trex decking slippery when wet?
Trex decking is a low-maintenance decking solution that requires a fraction of the work of wood decks and
is less likely to get slippery when wet
. It still requires occasional attention to keep it looking its best, but you’ll be delighted with the finished results.
How do you maintain Trex decking?
Spray deck with soap
, then follow by gently scrubbing each deck board with a soft bristle brush. Spray/rinse each individual deck board using a fan tip no closer than 8-in (203 mm) from the decking surface. RINSE THOROUGHLY. If dirty water from cleaning is left to dry, a film will remain on the decking surface.
