Yes, these two wires should be connected together . This is what allows the radio to retract the antenna when it isn't being used. Just because your wiring harness has a connection for this wire, it doesn't necessarily mean that your car has this kind of motorized antenna.
What do I hook the orange illumination wire?
The point of the illumination wire is to dim the brightness of the headunit when it senses that you've turned the headlights on . If you connect to either a 12v constant or 12v switched wire it will always be dim. You could put a switch in to manually dim it or tap the headlight switch if you wanted.
Do I need to hook up the illumination wire?
The illumination wire adjusts the brightness of the display on an aftermarket radio's faceplate. ... This is not mandatory for proper stereo operation, so many installers leave it unhooked for maximum display brightness.
What does the orange wire do on a car stereo?
The normal use of orange and orange/white wires is orange is for variable voltage to control display illumination dimming (i.e. the head unit display dims along with the other dash lights) while orange/white is a simple on/off signal of whether the dash lights are on (the head unit has only bright and dim display ...
What color is the illumination wire on a car stereo?
The 12V battery wire is yellow, the accessory wire is red, and the dimmer/illumination wire is orange with a white stripe . The right-front speaker wires are gray, left-front speakers are white, right-rear speakers are purple, and left-rear speakers are green.
What is the power antenna wire for?
When the ignition of the vehicle is turned off, the remote turn on wire stops transferring voltage and the amplifier turns off . ... This wire is typically for power antenna or factory amplifier turn on, do not get this wire confused with the remote turn on wire with the blue/white stripe.
Can I run my remote wire to my battery?
No , run the remote wire to the remote out on the back of the headunit. You can then install a switch on the remote wire to turn it on or off, but if you run it directly to the battery you will have problems because the amps will always be on, and you will kill your battery.
Where do you connect the reverse wire?
- I have an aftermarket radio with the reverse gear wire (purple/white stripe). ...
- The red wire passes the reverse signal up to the front of the car. ...
- It is used to indicate when the car is in reverse. ...
- The red wire is for power.
Which color wires go together?
US, AC:The US National Electrical Code only mandates white (or grey) for the neutral power conductor and bare copper, green, or green with yellow stripe for the protective ground. In principle any other colors except these may be used for the power conductors.
Where does the orange wire go?
The orange wire connects to terminal O on your thermostat.
Where does the yellow wire go on a car stereo?
The yellow wire is the 12 volt battery wire , which should also be attached to the stereo for power. The final wire, the black wire, is the ground wire. This wire, once attached to the stereo, will help ground it.
What is the orange and black wire in a car stereo?
Orange + Black = Beep . It's that beep you hear through the speakers when you program a station into the OEM radio.
What wire is the memory wire on a car stereo?
When you find one that shows approximately 12V, you have found the constant 12V wire , also known as the memory wire. It's yellow in most aftermarket head units.
Where do you wire an amp to turn on?
The turn-on wire (also called the remote wire) is located behind the stereo . On aftermarket stereos, it's usually a blue and white wire. The remote wire will “tell” your amplifier to turn on whenever the stereo is powered up (usually, whenever the vehicle is turned on).
How do you wire a power antenna?
Yes, these two wires should be connected together . This is what allows the radio to retract the antenna when it isn't being used. Just because your wiring harness has a connection for this wire, it doesn't necessarily mean that your car has this kind of motorized antenna.
Where does the blue wire go on antenna adapter?
Installation Note: A blue wire is attached to the antenna adapter. When installing the adapter, the blue wire should be connected to the antenna turn-on lead of your new head unit .
