To keep your log splitter splitting for many years to come, check the hydraulic fluid often. Before using your hydraulic log splitter, make sure the reservoir tank is filled. And after 100 hours of use, change out the hydraulic fluid and the filter .
What kind of hydraulic fluid does a log splitter use?
The approved fluids that our log splitter hydraulic systems may be filled with are: Dexron III Automatic Transmission Fluid or 10W AW Hydraulic Oil . A properly maintained hydraulic log splitter means faster yard waste clean-up and a well-kept lawn.
Do log splitters use hydraulic fluid?
Unless you use a kinetic powered log splitter, your machine is run off a hydraulic system to provide unparalleled wood splitting power. In short, you should always use the recommended hydraulic fluid provided by the log splitter manufacturer . ...
Where do you put hydraulic fluid in a wood splitter?
To add the appropriate amount of hydraulic fluid, you must first remove the oil filling plug . Then fill the hydraulic fluid unit until it is three-fourths full. After you have added the right amount of hydraulic fluid, you’ll need to remove, or bleed, the trapped air from the cylinder.
What oil is used in a wood splitter?
Oil Type. Electric log splitters require hydraulic oil with a 10W (Winter) weight rating . This hydraulic oil type provides lubrication for gears and other mechanical parts during extreme cold and heat, effectively protecting parts from wearing down.
How often should you change the hydraulic oil in a log splitter?
We recommend changing the oil after 150 hours of use . If you wish to learn how to change the oil, please visit our Downloads page. You can then download the latest manual for you log splitter.
Should I grease the beam on my log splitter?
Another obviously important part of your hydraulic log splitter is the ram. You need to keep the ram fully greased up . Keep every square inch of it greased, because a dry ram will quickly become a rusty ram. Rusted rams will damage the hydraulic seal, and you do not want to damage the seal.
How much hydraulic fluid goes in a wood splitter?
How Much Hydraulic Fluid is in a Splitter? Each log splitter is different in how much hydraulic fluid it takes. Most reservoirs 3.5 to 7 gallons depending on the size and power of the machine, but you should always check with your specific model’s need and manufacturer’s recommendations.
How do you add hydraulic oil to a log splitter?
To add the appropriate amount of hydraulic fluid, you must first remove the oil filling plug. Then fill the hydraulic fluid unit until it is three-fourths full . After you have added the right amount of hydraulic fluid, you’ll need to remove, or bleed, the trapped air from the cylinder.
How do you change hydraulic oil in a wood splitter?
- Place an oil collection container under the tank.
- Disconnect the suction hose from the bottom of the reservoir tank.
- Unthread the inlet filter screen and clean it with penetrating oil.
- Allow the fluid to drain into the oil collection container.
Can I use ATF in my log splitter?
There would be no advantage of using ATF over a standard 10w hydraulic oil. ATF costs a lot more $. A log splitter is about as simple of a hydraulic system as you can get. Almost any kind of oil would work fine in a splitter .
How often should you change hydraulic fluid?
Fluids. Because fluids are the lifeblood of any hydraulic system, you must take care to keep fluid levels and purity within the acceptable range. Check the fluids after the first 100 hours of operation, and replace them every 1000 hours after that, or as recommended by the manufacturer.
How often should you change hydraulic oil in a tractor?
How often should you change your oil? “We recommend changing the engine oil after the first 50 hours that you use the tractor and every 100 hours after that,” Colin said.
Why does log splitter lose power?
There are many different reasons why there may not be any power to your log splitter: If you’re using an extension lead, ensure that the extension cable itself is a wider diameter than the power lead of the electric log splitter . As stated previously, the capacitor failing will also stop the motor from starting up.
