Tongue-and groove-ceilings
must be stained before installation
for best results. If, however, the builder hung the roof without staining it first, finish the ceiling in the method suggested in the tips section. Then you’ll have to touch up the unstained portions of the tongue as they become exposed over time.
How do you stain your tongue and groove?
- Foam Brush. Staining allows the wood grain to show through. …
- Rag. A clean rag is an effective way to apply stain to tongue and groove boards. …
- Paint Brush. Stain may also be painted onto the boards. …
- Your Hand. Some people prefer the hands-on approach to staining.
Do you need to finish pine tongue and groove ceiling?
However, it is a
good idea to finish your pine rather than leave it in its natural state
. You must keep in mind that pine is a very soft wood and is vulnerable to just about anything. … A finish will help protect from wood oil, dirt, and moisture and keep it looking good for many years to come.
How do you finish a tongue and groove ceiling?
- Linseed Oil. If you are seeking a natural look for your tongue and groove ceiling, the easiest solution is a simple treatment with linseed oil. …
- Stain. Stain should be used with caution on ceilings. …
- Paint. Some homeowners choose to paint their tongue and groove ceiling.
Which way should tongue and groove ceiling be installed?
Install Planks
Start with your first piece:
groove facing the wall, tongue facing out
. Use the framing gun to add a nail to the tongue of the plank and secure in place. For the next piece, you will connect the groove of the new piece into the tongue of the first piece.
Do you have to seal knotty pine?
Pine tends to soak up wood stain unevenly, and knotty pine is especially prone to blotching. The way to circumvent this problem is
to seal the wood before you apply a stain or finish
.
Should I stain tongue and groove?
Tongue-and groove-ceilings
must be stained before installation
for best results. If, however, the builder hung the roof without staining it first, finish the ceiling in the method suggested in the tips section. Then you’ll have to touch up the unstained portions of the tongue as they become exposed over time.
How do you keep pine tongue and grooves from turning yellow?
- Use a water-based polyurethane finish. All other finishes are either slightly yellow going on, or themselves yellow with age.
- Keep the sun off the wood. Sunlight hastens the darkening process.
- A dark stain will mask the effect. The darker the better.
Do you need to stain both sides of tongue and groove?
Not Necessary
. Logic is usually a good guide, but it doesn’t always apply. A case in point is the widely held belief among woodworkers that the way to prevent warping is to apply finish to both sides of a board.
How do you calculate tongue and groove ceiling?
If the room is not already rectangular, mentally
divide it into rectangles
, as these will be easier to measure. In each rectangle, measure the length and width of the room and multiply the two together to get the area. Add together those totals to get the complete area of the room.
What is shiplap vs tongue and groove?
During installation, these notches fit together like little steps, so the
shiplap planks very slightly overlap
, in what is called a rabbet joint. … Tongue and groove planks, however, have a small projection sticking out of the center of one side’s edge, while the other side has a corresponding small indentation.
How much does it cost to install tongue and groove ceiling?
Labor Cost to Install Tongue and Groove Ceilings
Installing a tongue and groove ceiling costs
$2 to $3 per square foot
using unfinished wood and an extra $1 to $3 per square foot if hiring your local handyman.
What is cheaper shiplap or tongue and groove?
Shiplap is cheaper than tongue and groove
, but it requires a bit more work on the carpenter to get the rows to lay flat against the building in a waterproof fashion. Also, if not installed properly, shiplap is more likely to warp and leak than its counterpart.
