- Power unit down by turning off the circuit breaker(s) for one (1) minute.
- Power unit up by turning on the circuit breaker(s).
- Monitor the oven/range for one (1) minute to ensure the error code does not display again.
- Verify oven operation.
What does PF mean on Kitchen Aid oven?
PF code determines a power failure . It can be displayed 27 or 30 for PF id or 30 based on the model, however, the PF goes along well with KitchenAid oven units. Press cancel to clear the display and inspect to see to it that the time clock is accurate.
What does PF mean on my KitchenAid oven?
PF – Power Failure – PF error code indicates a power failure during the dryer’s cycle. Press and HOLD start to continue the cycle, or press off/pause to clear display.
How do I clear the error code on my KitchenAid oven?
Sometimes error codes can be cleared by resetting the power to the oven . You can do this at your circuit breaker box by turning off the circuit breaker or fuse, leaving it off for one minute, and then turning it back on. Often, this power reset will allow the stove to reboot and solve the problem.
Why is PF flashing on my stove?
PF indicates a power failure . After a power failure you will need to reset the clock before the controls will work again.
How do you unlock the controls for a KitchenAid oven?
To unlock the control panel, press and hold CONTROL LOCK for 3 seconds . The indicator light will turn off, and the appliance is ready for use.
What does F3 mean on Kitchenaid oven?
F3 – Open Oven Temperature Sensor (RTD) – Replace oven temperature sensor (RTD). F4 – Shorted Oven Temperature Sensor (RTD) – Replace oven temperature sensor (RTD). F5 – Control Board Failure – Replace control board (clock).
What is f2e1 error code?
There may be a problem with the Cooktop Control, or the associated wiring. Power unit down by turning off the circuit breaker(s) for one (1) minute. Power unit up by turning on the circuit breaker(s). Monitor the cooktop for one (1) minute to ensure the error code does not display again. Verify cooktop operation.
How do I get the temperature probe off my Kitchenaid oven?
If the temperature probe will not shut off even after the desired internal temperature is reached, press “Cancel/Off” on your oven’s keypad . Open the oven door and use an oven mitt to disconnect the probe from the oven.
The KitchenAid microwave reset process is fairly simple. Push the cancel/off button to clear the display . The error code should disappear. If call service or other code pops up, then remove power from the unit for one minute to reset the machine.
Why is my KitchenAid oven not working?
If the thermal fuse has blown, the oven will not turn on . ... To determine if the thermal fuse is at fault, use a multimeter to test the fuse for continuity. If the thermal fuse does not have continuity, replace it. The thermal fuse cannot be reset—if the fuse has blown, you must replace it.
How do you run a diagnostic test on a KitchenAid refrigerator?
To enter the diagnostics mode: Press the control POWER button and the water filter RESET button simultaneously for 3 seconds. To advance the diagnostics sequence: To advance to the next step in the sequence, press and hold the water filter reset button for 2 seconds or until it beeps.
What does PF mean on LG stove?
The PF display code is not actually an error code, but an indication that the unit has experienced a power failure .
What does PF mean on a gas range?
The PF message in the display usually indicates a power failure .
