- Remove the ice tray and cover plate (or just the ice tray). ...
- Turn the switch from on to off.
- Unplug the ice maker at the mains.
- Wait 10 minutes.
- Plug the ice maker in again.
- Turn the switch from off to on.
- Replace the ice tray and the cover plate as necessary.
Whirlpool places its water filters either tucked into the grille at the base of the appliance or in the upper right corner of the interior of the fridge. Locate the water filter and lift the plastic filter door. ... Reset the status by pressing and holding the water filter button for at least 3 seconds until it turns blue .
In most cases, to access the reset button, you will need to take the ice tray out . Once that is done, you will be able to see a bright reset button. This will mostly be located on the bottom of your ice maker. When you find this button, you will need to push it down and hold it for roughly for about 10 seconds.
Why is my Whirlpool ice maker not working?
In other instances, your a Whirlpool ice maker not making ice may be due to insufficient water supply . A clogged water filter, kinked water line hose, or defective water inlet valve can restrict the water flowing to an ice maker. ... Schedule a professional repair to replace a defective water inlet valve.
You can find the reset button at the bottom of the ice maker . Remove the ice tray to locate it. Remove the ice tray. The red button you see is the reset button.
How do I force my ice maker to cycle?
- Open the freezer door to remove the ice bin from below the ice maker.
- Empty the ice from the bin. ...
- Press the ice maker toggle switch to the “On” setting if it is not already activated.
- Pop off the front cover of the ice maker with the tip of a flat-blade screwdriver.
How do I run a diagnostic on my Whirlpool refrigerator?
To start with we need to start the refrigerator’s diagnostic mode. To do this open the refrigerator door and press one or both door switches , depending on your refrigerator type. Next press the refrigerator temperature (+) button three times in ten seconds and release the light switch or switches.
- If you have a side-by-side fridge, the water filter button is above the water tap on the outside of your refrigerator.
- The filter light and reset button are found inside the French door Whirlpool Fridge on the top right side.
How do you reset a Whirlpool refrigerator after a power outage?
How to turn on (reset) a Whirlpool refrigerator? The refrigerator and freezer controls are located on the dispenser panel (if applicable). Did the cooling mode turn OFF? Press and hold “Lock” and “Filter” simultaneously for three seconds to turn the cooling feature back on .
Why my ice maker is not working?
Cause: A common cause for a clog is frozen water in the line . ... Cause: There is also a possibility that the water filter for the ice maker is clogged. Fix: Locate and replace the water filter. Filters for ice makers are typically located inside the refrigerator (to keep them from freezing).
How do you troubleshoot an ice maker?
- Check the shutoff arm.
- Check the supply valve.
- Inspect the water supply line.
- Test the shutoff switch.
- Check the freezer temperature.
- Inspect the ejector gear.
- Test the ejector motor.
- Test the ice mold heater.
Why won’t my ice maker fill with water?
Water may not be reaching the ice maker due to a frozen line, missing filter , or a closed supply valve. ... When there is no filter, or it is clogged, the ice maker does not get water. Make sure that the filter is in place, and if it has not been changed in more than six months, replace it with a new one.
Some Frigidaire refrigerators have an an on/off button for the icemaker located on the front control panel. To reset the icemaker press this switch until the LED turns red, wait a few minutes, then press and hold it until the LED turns green .
