How Do You Bypass The Anti-theft System On A 2004 Pontiac Grand Prix?

start outside your car with all of the doors closed.

hold

the lock and unlock on your keyfob together until it honks and flashes the lights. get in and turn the key to on, but don’t start the car. give it a good 30 seconds until the security lights aren’t flashing…you should be able to start after that.

How do you override anti-theft system?

Turn the key to unlock

your car door, but don’t release it. Hold the key in this position for 20 to 30 seconds. This lets the system know you have the correct key, and it can allow you to bypass the alarm system. Some vehicles recognize the key simply by turning the key back and forth in the door lock key cylinder.

How do I get my car out of anti-theft mode without remote?

1. Close all of your car doors.
2. Insert one key in the door lock and cycle it to the “Lock” position, and then back to the “Unlock” position two times. …
3. Enter your car and insert your key into the ignition cylinder.
4. Cycle the key in the ignition from the “Off” position to the “On” position twice in a row.

How do I permanently disable anti-theft system?

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
2. Look at the dashboard and locate the theft system light.
3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

How do you bypass anti-theft on a Pontiac Grand Prix?

start outside your car with all of the doors closed.

hold the lock and unlock on

your keyfob together until it honks and flashes the lights. get in and turn the key to on, but don’t start the car. give it a good 30 seconds until the security lights aren’t flashing…you should be able to start after that.

Why is my car in anti theft mode?

The anti-theft system of your car

may not work properly at a certain time

. This may be for many reasons, including a dead car battery that loses memory of your key or a dead remote control battery. It may also be that the immobilizer chip is damaged on your key or the car door lock is damaged.

Will disconnecting battery reset anti theft?

By

unplugging the battery for a few minutes

, it will also reset the computer. … All you have to do is disconnect the positive or negative terminal and wait.

How do I know if my anti theft system is bad?

If the security or anti-theft light is flashing when you attempt to start your car, and the

engine does not crank or does not start

, you have an anti-theft problem. The system may not be recognizing your key or keyless entry signal, or there may be a fault in the anti-theft module, keyless entry system or wiring.

How do I get my Ford out of theft mode?

If you need to reset the anti theft system on a ford f150 you should : step 1 insert your first programmed key into the

car’s ignition

and turn it to the “on” position. Step 2 cycle the first key back “off,” remove it from the ignition and insert the second programmed key within 5 seconds.

Where is the anti-theft fuse located?

It is usually located

on the dashboard by the driver’s door

, in front of your left knee. You may find the alarm fuse in this fuse box. If you do not find an alarm fuse inside of the car, look in the fuse box under the hood on the driver’s side. Your car model may or may not have additional fuse boxes.

How do I get my Impala out of security mode?

Make sure

the security light is

flashing. After 10 minutes the security light will stop flashing and either turn off or stay on steadily. Put the key in the On position. Wait ten minutes until the security light on the dash stops flashing.

How do I get my Mustang out of theft mode?

To reset the anti-theft on the vehicle You will need to first get into the

vehicle and shut the doors

. With the doors shut You want to put the key into the ignition slot and turn it on. Once You have turned it on You will then want to turn it back to the off position.

How do you disable an engine immobilizer?

Insert the key into the ignition and turn it to the on position, which activates your accessories but not the engine. Leave the key in position for about 10 – 15 minutes. Step 3: Check the anti-theft light again. If it’s no longer blinking, turn the key back to the Off position and allow it to set for a minute or two.

What does it mean when the anti-theft light is blinking?

Your car has a built-in anti-theft system. … The Anti-theft Light in the dash of your car should flash

periodically to show that the system is engaged and active

. Tip. You have to lock the doors of the car (without it running) for the alarm to engage.

What does the car with the lock symbol mean?

The lock and car symbol and warning light you are seeing is saying that

the anti-theft system has been activated

. … If the anti-theft system is stopping the vehicle from wanting to start, it may be contributing to the starting issues. The first thing you should do is try to deactivate the security system.

How do I reset my ignition key?

1. turn key to ON for 10 minutes 30 seconds.
2. turn key to OFF for about 10 seconds.
3. back to ON for 10 min 30 sec.
4. back to OFF for about 10 seconds.
5. On for 10:30.
6. OFF for about 10 seconds.
7. ON.
8. Start the engine.