Open the trunk or any door of the Impala.
Switch the lock to the “lock” position
. Remove the key from the ignition. The light on the radio display will flash quickly; this signals that the system is resetting.
How do I get my car out of anti theft mode?
Step 1: Insert the key into the door lock. Use the side door on the driver’s side and the physical key even if there is a keyless entry system on the car. Step 2: Turn the vehicle key to unlock the car door without releasing it. Hold the key for 30 seconds in the position.
How do I disable GM Anti-theft system?
The vehicle should start, and then stall while the SECURITY light flashes. Leave the key at the ON position for 10 minutes and wait for the SECURITY light to go away. Turn the key to the OFF position for 5 seconds and restart the car. The car should start and the SECURITY light should remain off.
How do I reset my GM Anti theft system?
- Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position. …
- Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.
How do I get my Impala out of theft mode?
To reset the anti-theft system in the 2007 Chevy Impala,
turn the key in the ignition to the “on” position and attempt to fire the engine
. Return to the “on” position. The vehicle will not start if anti-theft has disabled the ignition. After 10 minutes, the flashing “security” warning light should power off.
Is my car in anti-theft mode?
If the security or anti-theft light is flashing when you attempt to start your car, and the engine does not crank or does not start, you have an
anti-theft problem
. The system may not be recognizing your key or keyless entry signal, or there may be a fault in the anti-theft module, keyless entry system or wiring.
How do I reset the security system on my car?
- Close all of your car doors.
- Insert one key in the door lock and cycle it to the “Lock” position, and then back to the “Unlock” position two times. …
- Enter your car and insert your key into the ignition cylinder.
- Cycle the key in the ignition from the “Off” position to the “On” position twice in a row.
Where is the anti-theft fuse located?
It is usually located
on the dashboard by the driver’s door
, in front of your left knee. You may find the alarm fuse in this fuse box. If you do not find an alarm fuse inside of the car, look in the fuse box under the hood on the driver’s side. Your car model may or may not have additional fuse boxes.
Can anti-theft stop car from starting?
Anti-theft systems are
designed to prevent your vehicle from being stolen
. These systems are constantly evolving. Essentially, they work via an electrical circuit disconnecting to prevent power from flowing so your car won’t start or will die immediately.
Will disconnecting battery reset anti-theft?
By
unplugging the battery for a few minutes
, it will also reset the computer. … All you have to do is disconnect the positive or negative terminal and wait.
How do I fix PASSLock on GM?
- Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position. …
- Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.
What triggers anti-theft?
An impact or the movements inside the car activates the sensors
. This, in turn, triggers the Anti-theft alarm system and sounds the alarm. The alarm goes off and alerts the owner/people. Even, the change in the vehicle’s position can alert the tilt sensor and activates the anti-theft alarm system.
What does the car with the lock symbol mean?
The lock and car symbol and warning light you are seeing is saying that
the anti-theft system has been activated
. … If the anti-theft system is stopping the vehicle from wanting to start, it may be contributing to the starting issues. The first thing you should do is try to deactivate the security system.
What does it mean when the security light stays on in your car?
On your particular vehicle the security light staying on as the vehicle is running is an
indication that the security system has failed and is disabled
. … With the security light being on there is a possibility that the vehicle will not restart once you cut it off.
How do I bypass immobilizer?
You can bypass the immobilizer
by placing the key in keyhole
hence deactivating the car’s immobilizer to remote start. The added security with Mobokey allows the security to be activated as soon as the phone moves away from the car, so you don’t have to worry about car security.
What does it mean when you turn your key and nothing happens?
If nothing happens when you turn the ignition key to the “Start” position, it means that
the starter motor doesn’t turn over the engine
. Most commonly this could be caused by a dead battery; read above How to check the battery. … The ignition switch could be bad – it’s a common problem.
