- Honda Rancher 350 Oil Change. …
- Get a drain pan under your machine, then find the 17mm drain bolt on the centerline of the engine, toward the gearshift. …
- Inspect the crush washer on the drain bolt while the oil drains. …
- Replace the drain bolt once the engine oil has drained completely.
How do you change the oil on a 2003 Honda Rancher 350?
Fill up the engine with Honda 10W-30 motor oil through the fill opening on the left side of the engine, opposite the dipstick opening on the right. NOTE: The Honda Rancher 350 takes a little
over 2 quarts
of oil, so start off by pouring in just 2 quarts.
How much oil does a 1986 Honda Fourtrax 350 take?
3 Quarts
of Honda GN4 10W-40 4-Stroke Motorcylce Oil.
How much oil does a Honda ATV take?
PRO TIP: Honda says the oil capacity of the Rancher 420 is
3 quarts
, but we found that can be a little too much. Pour in 2.5 quarts, replace the fill cap, run the engine for a couple of minutes, and then check the level. To check the oil level on the engine, don't screw in the fill cap.
How do you change the oil on a Honda Fourtrax?
NOTE: Honda specifies that the TRX300 engine takes
2.4 quarts
of GN4 10W40 oil.
What oil goes in a Honda Fourtrax 350?
Fill up the engine with
Honda 10W-30 motor oil
through the fill opening on the left side of the engine, opposite the dipstick opening on the right. NOTE: The Honda Rancher 350 takes a little over 2 quarts of oil, so start off by pouring in just 2 quarts.
What oil does a 1986 Honda Fourtrax 350 take?
3 Quarts of
Honda GN4 10W-40 4-Stroke Motorcylce
Oil.
What kind of oil does a 2003 Honda Rancher take?
3 Quarts of
Honda GN4 10W-40 4-Stroke Motorcylce Oil
.
Does a Honda Rancher use transmission fluid?
Using a properly formulated transmission fluid or differential fluid for your Honda Rancher AT can protect your ATV from costly problems down the road.
AMSOIL Synthetic ATV Transmission and Differential Fluid
offers excellent protection for your Rancher AT, even in the most severe riding conditions.
How much oil does a 2004 Honda Rancher 400 hold?
4 Quarts
of Honda GN4 10W-40 4-Stroke Motorcylce Oil. **Kit includes One Genuine Honda OEM Oil Filter and One Crush Washer.
Can you use synthetic oil in a Honda ATV?
Yes,
you can use a synthetic oil
. Amsoil has them specifically for ATV's. GN4 is a standard oil, but if your engine works a little harder, we recommend using Honda HP4 semi-synthetic oil instead.
How often do you change oil in ATV?
In general, you're supposed to perform an ATV oil change about every 100 hours of use, or
at least once per year
. But be sure to check your owner's manual to find out what it says about your specific ATV.
How much oil do you put in a Honda Rincon?
A Honda Rincon requires
3 quarts
of fresh Honda HP4 or similar 10W40 motor oil when replacing the oil filter.
How much oil does a Honda Fourtrax 350 take?
3 Quarts
of Honda GN4 10W-40 4-Stroke Motorcylce Oil.
How do you check the oil on a Honda Rancher?
To check the oil level on the engine, don't screw in the fill cap.
Just plunge it in and remove it, then top the engine off with oil to set the level
.
How do you reset the oil light on a Honda Rancher?
Turn the ignition on without starting the engine. Press and hold the trip meter select button.
Press and hold the “Reset” button
. Release both buttons after the oil light disappears.
