How Do You Fill A Transfer Case On A Ford Ranger?

1. Position the vehicle on level ground.
2. Remove the transfer case fill plug (the upper plug) located on the rear of the transfer case. The fluid level should be up to the fill hole.
3. If lubricant doesn’t run out when the plug is removed, add lubricant until it does run out.
4. Replace the fill plug.

What is Motorcraft transfer case fluid?

Motorcraft

^®

Transfer Case Fluid is manufactured with

high-viscosity index

, premium-quality, hydroprocessed base oils and specially designed performance additives to provide increased protection against deposit, rust, corrosion, and wear and maintains proper viscosity at extreme temperatures.

What kind of fluid goes in a Ford Ranger transfer case?

The recommended type of transfer fluid used in the Ford Ranger is

ATF 4, or automatic transmission fluid

. It is also referred to Mercon V. The vehicle has a transfer fluid capacity of 1.2 liters. You can find it at any automotive parts and accessories retail location.

Is transmission fluid the same as transfer case fluid?

The transmission and front differential share the same fluid (ATF)

. The transfer case (uses Gear Oil) is a separate unit.

Can I use dexron 3 in my transfer case?

Although Dexron III is called out as the proper fluid for the transfer case, GM has deprecated Dexron III and replaced it with

Dexron VI

. ( a synthetic transmission fluid originally thought to be completely backward compatible for all uses).

What happens if transfer case is low on fluid?

Difficulty changing gears – Low or dirty transfer case fluid can affect your transmission’s ability to shift gears. It can also result in your car unexpectedly falling out of four-wheel drive.

Loud noises while driving

– As the transfer case fluid loses its lubricating properties, friction will occur inside.

Can I put transmission fluid in my transfer case?

Transfer cases may be filled with

gear oil, automatic transmission fluid (ATF)

, or specialty lubricants. It is important to regularly inspect the transfer case for any damage, leaks, or other concerns.

How often should you change transfer case fluid?

You should have your differential and transfer case fluid checked

every 30,000 miles

, or when you experience any of the symptoms below. Changing these fluids is a messy job, but your local Brakes Plus team is here to help – we never mind getting our hands dirty!

Is Mercon V the same as Mercon LV?

Over the years, the original

Mercon

was supplanted by Mercon “V”, Mercon “SP”, Mercon LV, and Mercon ULV which is the latest fluid.

What is equivalent to Mercon LV?

It’s said on the bottle that it is certified by Ford for Mercon LV applications. Later, I did some research and found two other certified products:

Castrol/Transmax ATF full synthetic multi-vehicle transmission fluid

available from Autozone and Silver State Dex VI / Mercon LV ATF.

How do you know if your transfer case is low on fluid?

If you hear grinding, growling, or humming noises that change with your vehicle speed

, it may be coming from the transfer case. This could indicate a low fluid level or some mechanical problem such as bad bearings, loose chains or damaged gears.

How do I check my transfer case fluid level?

Locate the oil fill plug on the transfer case. Remove the top oil fill plug. Using a flashlight, check for

oil at the fill plug hole

. When full, the oil should be just below the top hole.

How do you add fluid to a transfer case?

Locate the filler plug on the side of the transfer case. Clean the filler plug and the area around it using a shop rag; this avoids contaminating the new transfer case fluid. Using a wrench or ratchet and socket, remove the filler plug. Add the new fluid to the

case using a small funnel

.

What fluid goes in a 261 transfer case?

Recommended fluid for the NP261 transfer case is

automatic transmission fluid (ATF)

.

Can I use dexron 6 in my transfer case?

As for the use of Dexron 6 it

can be used in anything

that was once dexron 3 except for dexron 3 being used in 2005 and newer vehicles. They must use Dexron 6. As for the transfer case in my truck it is a electronic shift but still classed manual since it does not have the AUTO 4X4 button on the console.

How much fluid does a 246 gm transfer case hold?