How Do You Remove The Battery From A Road King?

1. Unscrew the bolt securing the passenger seat to the Road King's rear fender, using a Phillips screwdriver. …
2. Unscrew the nuts from the back of the rider's seat, using a 1/2-inch socket. …
3. Unscrew the battery clamp bolt, using a Torx driver.

How do I remove my bike battery?

1. Read the manual (RTFM) …
2. Find the battery, and then access it. …
3. Disconnect the negative cable. …
4. Remove the positive cable. …
5. Remove the battery. …
6. Install the new battery (or the charged one if you pulled yours out to charge it) …
7. Hook up the cables. …
8. Test it!

How do you access a motorcycle battery?

On almost all motorcycles the battery is

located under the rider's seat / saddle

. To gain access to the motorcycle battery you will most likely need to first remove the saddle. A key lock is often located somewhere around the saddle. Once you turn the key the saddle will release and you will see it pop up slightly.

Can you jump a motorcycle with a car?

It is possible to jump start a motorcycle with a car

. This method should be used as a last resort as there are a lot of risks to the motorcycle. When a car is running, the voltage can run high enough to damage the electronics that are on a motorcycle, but if you're careful, jumping it with a car is a valid option.

Can a completely dead motorcycle battery be recharged?

If you do have a dead battery, you

can recharge it with a battery charger

(this is preferred), or by jumpstarting your bike with another bike or a car.

Does a motorcycle battery charge while idling?

Technically, a

motorcycle battery does charge while the motorcycle is idling

though it does not provide as much amperage as when the motorcycle is at higher speeds. During a normal ride, a motorcycle provides about 13, 14, or 15 amps while idling only provides less than 1 amp.

How long does it take to charge a motorcycle battery while riding?

That's what is designed to happen, so if your alternator and battery are in fine fettle, a

30 minute ride

should easily be enough to top up the battery.

Where is the battery in a Harley Davidson?

Getting the old battery out is the first step in getting back on the road, but removing it in the first place can seem tricky. Most Harley-Davidson models

house their batteries on the side of their frames

. The Road King, however, conceals its battery under the seat.

What does the red key light mean on a Harley?

7,340 Posts. #6 · May 14, 2013. Only show this user. If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the

bike has thrown a DTC

. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car.

What is the default Harley security code?

VIDEO-If your Harley Davidson is equipped with a factory installed alarm then you really need to immediately change your security PIN code. Harley puts a standard factory preset PIN code and it is usually

31313

.

How do you remove a motorcycle battery charger?

Generally, to remove a battery you must

disconnect the negative cable first and then the positive cable

. Then, release the battery from anything connecting it to the motorcycle body and lift it out of the bike.

Should I disconnect my bike battery?

Prevent these draws from killing your battery, disconnect the battery. Even if there is no load on, batteries self-discharge. When batteries are left discharged, they quickly become sulfated and may permanently lose the ability to be charged. The best practice is to

keep your battery on a maintainer at all times

.

Should I remove my motorcycle battery?

Unplugging it alone won't slow the discharge down significantly, since your battery probably only powers your clock when the ignition is off, which is a negligible power draw. Motorcycle batteries have a much smaller capacity than car batteries, so any loss of capacity has potentially a greater impact than in a car.

Can you kickstart a motorcycle with a dead battery?

Generally,

yes

. In case one has a completely dead battery where the horn won't sound or the headlights can't glow, and for a manual transmission car that supports being push-started, even borrowing a 12v motorcycle battery and connecting it up with cables will allow the engine to fire up with a push start.

How do I bring my motorcycle battery back to life?

1. Step 1 – Remove the Battery and Clean the Posts.
2. Step 2 – Check Battery Open-Circuit Voltage.
3. Step 3 – Check Cell Voltage and Health.
4. Step 4 – Refill Cells with Epsom Salt.
5. Step 5 – Fully Charge the Battery.
6. Step 6 – Now You Have to Repeat the Open Circuit Voltage Test.

How do you jumpstart a dead motorcycle battery?

#1 Connect jumper cables in the same order as with jump-starting from another motorcycle –

attach the red, positive clip to the positive terminal of your dead battery

and attach the other red, positive clip to the positive terminal of the car battery.

How long does it take to recharge a dead motorcycle battery?

Conclusion. Recharging your motorcycle battery should take

2-3 hours, but may take up to 24 hours

. Make sure not to overcharge it, or use a smart charger to be sure.

How do you remove a Softail Deluxe seat?

Removal of Stock Seat:

Remove the rear 1⁄4”-20 screw from behind the passenger seat with a Phillips screwdriver

. Slide the passenger seat up and back to remove from the motorcycle. 2. Remove the threaded spacer and washer from the rear mount hole on the rack using a 1⁄2” hex wrench.

Is it bad to bump start a motorcycle?

“Pushing a

bike to start it is potentially unsafe because it can topple over, injure the rider if they trip over or become a traffic hazard

,” he says. “Also, if a bike doesn't start after pushing then the rider has the additional problem of trying to get it back to where they started from.

How do you take the seat off a Harley Davidson Dyna?

1. Unscrew the seat bolt from between the sissy bar's legs, positioned on a bracket above the rear fender, using a Phillips screwdriver.
2. Lift the rear of the seat upward slightly to provide clearance above the rear fender.

What voltage is a Harley battery?

Harley-Davidson motorcycles use either a

6 volt or a 12 volt battery

. Harley-Davidson motorcycles made after the early 1960s are using 12 volt batteries, while older Harleys made before the early 1960s are using a 6 volt battery. If a Harley was made in the last 40 to 50 years, it uses a 12 volt battery.

Will a motorcycle run with a bad battery?

If you have a bad battery, can you still ride your motorcycle? The answer is

yes

, usually. As long as your battery is still capable of starting your motorcycle, you can still ride it around.

What is the average life of a bike battery?

Most batteries have an expected lifespan of

two years

, but you can increase that considerably if you maintain it properly. John says average lifespan is likely to be around two to three years, if it's well maintained, although some batteries manage quite a bit more.