How Do You Reset The Computer On A 2004 Pontiac Grand Prix?

2004 Pontiac Grand Prix GT?

Turn the key ahead to run mode, without cranking and push gas pedal to floor and back up 3 times within 5 sec

, this should reset the oil change light.

How do I reset my 2004 Pontiac Grand Prix?

1. Turn the ignition key to the “ON” position. Don’t start the engine!
2. Fully press and release the accelerator pedal to the floor slowly 3 times within five seconds. …
3. Turn the ignition off and then start the engine to verify the indicator has been reset.

How do you reset the ABS light on a 2004 Pontiac Grand Prix?

1. Open the hood and turn off the Grand Prix’s engine.
2. Disconnect the battery from the vehicle using a socket wrench. Wait three minutes. Reconnect the battery and turn the engine on to check the ABS light. If it is off, the sensor is reset. Close the hood.

What is the value of a 2004 Pontiac Grand Prix?

2004 Pontiac Grand Prix Value –

$490-$3,182

| Edmunds.

Can you rebuild ABS module?

There are a number of common ABS issues that can happen. An ABS module repair and return service is a service wherein the original

part is rebuilt

and does not need to be coded to your vehicle VIN.

Why is my ABS and TRAC off light on?

If the brake system is malfunctioning, the traction control light might come on as a result. The light for your ABS might also come on

if the brake fluid is low

. Your car likely has sensors in those tanks in order to detect when fluids are low, which could be dangerous.

Is a 2004 Pontiac Grand Am a good car?

Comfort 5.0. Interior design 5.0. Performance 5.0.

How do you fix an ABS control module?

If your ABS Warning Light turns on frequently, your mechanic can try to reset the ABS control module (like resetting a computer) to see if it fixes the problem by:

Disconnecting the positive cable from the vehicle battery

.

Holding down on the brake pedal to drain the vehicle’s electrical system

.

How do I reset my ABS module?

Resetting Your ABS Dashboard Warning Light

Then, hold down the brake pedal to drain the vehicle’s electrical system. This will result in a reset of the car’s central computer.

Plug the cable back in to restore

power. If there’s no remaining problem with the system, this should reset the light.

How do you test a bad ABS module?

1. The ABS Warning Light Glows. This is the most common sign of problems with the ABS system. …
2. The Brakes Lock Up. The ABS system is specifically designed to prevent any wheel from locking up during heavy braking. …
3. An Unresponsive Brake Pedal. …
4. Increased Pedal Effort. …
5. Speedometer Failure.

Can I drive with my ABS and traction control light on?

If the TCS and the ABS warning lights both come on, along with the red main brake warning light, you

should not drive the car until the problem has been fixed

. Your entire braking system is affected, and may not be able to stop your vehicle when you need it to. Have your vehicle towed to a repair shop.

Can I drive my car with the traction control light on?

It is only safe to drive with the TCS light on if it appears when you are losing traction

: it means the system is engaging. Driving without traction control can make your vehicle susceptible to spinning out and sliding around on the road. … Driving with your TCS Light on can be dangerous.

Can blown fuse cause ABS light to come on?

This may be a glitch or more commonly, a blown fuse. Sometimes a blown fuse to

the ABS can cause the light to come on

and stay on. Fuses are easy to blow, so sometimes it’s an easy fix to check.