Turn the ignition on without starting the engine. Press and hold the trip meter select button. Press and hold the “Reset” button . Release both buttons after the oil light disappears.
How do you reset the oil light on a 2021 Honda Rancher?
Turn the ignition on without starting the engine. Press and hold the trip meter select button. Press and hold the “Reset” button . Release both buttons after the oil light disappears.
How do you reset the oil light on a 2016 Honda Rancher?
Turn the ignition on without starting the engine. Press and hold the trip meter select button. Press and hold the “Reset” button . Release both buttons after the oil light disappears.
What does the wrench light mean on a Honda Rancher 420?
It indicates that it is time for a maintenance/oil/filter change . It will come on at 100 miles, and then every 600 miles thereafter.
How do you clear the codes on a Honda Rancher?
Turn the ignition on without starting the engine. Press and hold the trip meter select button. Press and hold the “Reset” button . Release both buttons after the oil light disappears.
How do you reset the angle sensor on a Honda Rancher?
To reset the system on the 99 turn the key switch on and hold both up and down shift buttons for 3 to 8 seconds. Turn the key switch off, then turn it back on.
How do you reset the oil light on a 2016 Honda Foreman 500?
- Turn the ignition on without starting the engine.
- Press and hold the trip meter select button.
- Press and hold the “Reset” button.
- Release both buttons after the oil light disappears.
Where is the oil filter on a Honda Rancher 420?
The filter is found on the right side of the engine and can be seen as #4 in our Rancher front crankcase cover diagram. Some oil will leak out, so get a rag underneath it to avoid a mess. Take off the three 8mm bolts to remove the cover and expose the filter, then pull the filter out.
How do you reset the oil light on a 2007 Honda Rancher 420?
Turn the ignition on without starting the engine. Press and hold the trip meter select button. Press and hold the “Reset” button . Release both buttons after the oil light disappears.
How do you reset the maintenance light on a Honda Pioneer 1000?
Once you changed the oil to reset it push and hold the button on the meter (with key off), turn key on while holding the button and within a few seconds the wrench will be gone.
How do you reset the oil light on a 2013 Honda Rancher 420?
Turn the ignition on without starting the engine. Press and hold the trip meter select button. Press and hold the “Reset” button . Release both buttons after the oil light disappears.
What does angle sensor do on ATV?
they control the angle of the shifting shaft when it shifts gears . and they are tied to the speed sensor to tell the ecu through the display how fast your atv is moving ?, this intel, keeps the shifting motor from only shifting at certain speeds.
What does PS mean on 4 wheeler?
6 PS ( Electric Power Steering ) indicator Lights when there is an abnormality in the PS (Electric Power Steering) system.
How do you test an angle sensor?
To test the SAS, you have to back probe a connector that is typically under the steering column . As the steering wheel is turned 360 degrees, the SAS produces a signal that toggles between 0 and 5 volts. As the wheel is turned lock-to-lock, the voltage will reach 5 volts three times and 0 volts three times.
What is a Honda bank angle sensor?
The Bank Angle Sensor is a vehicle sensor which detects the angle at which the vehicle (particularly motorcycle or bike) leans as seen from the front . This angle determines the maximum tilt the motorcycle can have safely without tipping over.
