Turn the ignition on without starting the engine. Press and hold the trip meter select button.
Press and hold the “Reset” button
. Release both buttons after the oil light disappears.
How do you reset the oil light on a 2021 Honda Rancher?
Turn the ignition on without starting the engine. Press and hold the trip meter select button.
Press and hold the “Reset” button
. Release both buttons after the oil light disappears.
How do you reset the oil light on a 2016 Honda Rancher?
Turn the ignition on without starting the engine. Press and hold the trip meter select button.
Press and hold the “Reset” button
. Release both buttons after the oil light disappears.
How do you reset the oil light on a Honda four-wheeler?
- Turn the ignition on without starting the engine.
- Press and hold the trip meter select button.
- Press and hold the “Reset” button.
- Release both buttons after the oil light disappears.
- Turn the car's systems on, but leave the engine off. …
- Locate the “Reset” button or stick, which is typically located on the dashboard, near the speedometer and fuel gauge.
How do you reset the oil light on a Honda Rancher?
Turn the ignition on without starting the engine. Press and hold the trip meter select button.
Press and hold the “Reset” button
. Release both buttons after the oil light disappears.
What does a wrench mean on a Honda Rancher?
It indicates that
it is time for a maintenance/oil/filter change
. It will come on at 100 miles, and then every 600 miles thereafter.
How do you clear the codes on a Honda Rancher?
Turn the ignition on without starting the engine. Press and hold the trip meter select button.
Press and hold the “Reset” button
. Release both buttons after the oil light disappears.
How much oil does a Honda Rancher 420 take?
PRO TIP: Honda says the oil capacity of the Rancher 420 is
3 quarts
, but we found that can be a little too much. Pour in 2.5 quarts, replace the fill cap, run the engine for a couple of minutes, and then check the level.
How do you reset the oil light on a 2013 Honda Foreman?
To reset the indicator,
press and hold the odometer/tripmeter/hourmeter select button and turn the ingnition switch to ON for more than 5 seconds and then turn off
, oil change indicator is reset.
How do you reset the oil light?
Turn the
ignition back to
the ON position while holding the reset button. Watch the oil change or maintenance light carefully. It should start to blink. Allow the light to blink ON and OFF for a few seconds, then release the reset button and turn the ignition OFF.
Why is my change oil light still on?
If your oil light stays on even after changing your engine oil, you're going to want to
check the sensor first to rule out a malfunctioning sensor as the cause
. … The oil pump may not be circulating enough oil to keep the engine's parts lubricated and functioning properly, which can in turn cause multiple engine issues.
Why won't my change oil light go off?
Check the oil. The light is a
warning signal that you are low on oil
or that the oil is not flowing properly. If the oil level is fine then the issue may be a reset button. Two different methods will allow you to reset the oil light.
How do you reset the computer on a Honda Rancher 420?
hold both the up and down shift buttons and turn the switch on
. then release and press up – down – up , move the throttle lever from fully closed to fully open and then back to fully closed.
How do I service my Honda quad?
- Clean air cleaner.
- Inspect and clean air cleaner housing drain tube.
- Inspect and clean, and adjust spark plug or replace if necessary.
- Replace engine oil.
- Replace engine oil filter.
- Inspect radiator coolant or replace if necessary.
- Inspect and clean, and adjust drive shaft boots.
How much oil does a 2005 Honda Rancher 400?
Description.
4 Quarts
of Honda GN4 10W-40 4-Stroke Motorcylce Oil.
