How Do You Reset The Tire Pressure Light On A 2009 Toyota Camry?

by | Last updated on January 24, 2024

, , , ,

To reset the system, first make sure the tire pressures are correct.

Turn the engine on, then press and hold the reset button

. You’ll find it low and to the right of the steering wheel on the instrument panel. Hold the button down until the TPMS indicator light in the instrument panel blinks slowly 3 three times.

Where is the TPMS reset button on a 2009 Toyota Camry?

Locate the tire pressure reset switch located

below and to the right of the steering wheel

(on instrument panel, knee bolster or inside glove box). Press and hold the switch until the tire pressure light flashes 3 times. Drive straight at approximately 25mph or more for about 10 to 30 minutes.

How do you turn off the tire pressure light on a Toyota Camry?

With the vehicle off,

turn the key to the “On” position

, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it. Start the car and wait 20 minutes for the sensor to refresh.

Where is the TPMS reset button?

The TPMS reset button is usually located

beneath the steering wheel

. If you are unable to find it, refer to your vehicle’s owner’s manual. Inflate all tires to 3 PSI over their recommended amount, then deflate them completely.

How do you reset the TPMS light on a 2008 Toyota Camry?

TPMS reset button, closed loop

Some Toyota models have a “SET” or “TPMS RESET” button, which is located

below the steering wheel or under the glovebox

. When the button is pressed, the system tries to locate the sensor ID’s that are already stored.

Why is my tire pressure light on when my tires are fine?

In most cases, the warning light may be triggered by a tire that is

10% to 15% low in air pressure

. Cold or icy weather also has a tendency to lower the air pressure inside the tires. Taking the car for a short drive will heat up the tires and increase the tire pressure.

What is the correct tire pressure for a 2009 Toyota Camry?

The tire size for the 2009 Toyota Camry is P215/55R17. The recommended tire pressure for the 2009 Toyota Camry is

32 psi

.

What is a TPMS reset button?

TPMS stands for Tire Pressure Monitoring System. In most vehicles the TPMS reset button is

found beneath the steering wheel

. After changing the tires on your vehicle, the TPMS needs to be electronically reset in order to clear the error code. … Start your vehicle and wait 20 minutes and the sensor will refresh.

How do I reset my TPMS light?

Turn the car key to “on” but don’t start the vehicle.

Press and hold the TPMS reset button until the tire pressure light blinks three times

. Release the button and start the car. The light should go off within 20 minutes.

Why is my TPMS not working?

TPMS problems can include any of the following: …

The TPMS module itself is not functioning properly

or has failed because of a voltage supply, wiring or internal electronics fault. • The tires were serviced or rotated recently and the relearn procedure was not done correctly.

How do you reset the TPMS light on a 2011 Toyota Camry?

With the vehicle off, turn the key to the “On” position, but don’t start the car. Hold the TPMS reset button until the tire pressure light blinks three times, then release it.

Start the car and wait 20 minutes for the sensor to refresh

.

How much does it cost to replace TPMS?

Generally speaking, the TPMS sensor replacement cost is going to fall somewhere

between $230 and $750

in most cases. And unlike some other auto repairs, it’s the parts, not the labor, that are going to get you. TPMS sensors can cost anywhere from $180 to $680 alone.

What should the tire pressure be on a 2008 Toyota Camry?

Recommended tire pressure for 2008 Toyota Camry is

30 psi to 32 psi for front tires

and 30 psi to 32 psi for rear tires.

Why wont my TPMS light go off?

If you’ve inflated your tires to the proper air pressure, but the warning light stays on, you may have

a leak

or there’s a problem with the TPMS in one or more of your tires. It’s simple enough to check if there’s a leak in a tire. Just use your tire gauge to recheck the air pressure in all your tires.

How do you know if you have a bad TPMS sensor?

If you find that you have tires with low air pressure and there was no alert from the system, it must be because of a bad TPMS sensor. You can

check your tire pressure with a tire pressure gauge

to confirm that you really have a low tire pressure. Jerky steering wheel.

Is it okay to drive with tire pressure light on?


It’s not safe to drive around with your TPMS light illuminated

. … If the light comes on while you’re driving, slow down and get to the nearest gas or service station to inspect the tire.

David Evans
Author
David Evans
David is a seasoned automotive enthusiast. He is a graduate of Mechanical Engineering and has a passion for all things related to cars and vehicles. With his extensive knowledge of cars and other vehicles, David is an authority in the industry.