How Much Concrete Do You Need For A 2 Post Car Lift? - Fixanswer

Here are our tips for making sure your installation is an uplifting experience. Some of manufacturers standards for a 2-Post and 4-Post Lifts require a

minimum 4 inches of reinforced

concrete slab to be safely installed.

How thick of a floor for a lift?

Some of manufacturers standards for a 2-Post and 4-Post Lifts require a

minimum 4 inches of

reinforced concrete slab to be safely installed.

How tall does a garage need to be for a 2 post lift?

If you want to install a typical 2-post or 4-post lift in your garage, you need a

ceiling that’s higher than 11 feet

. While you can get a 2- or 4-post lift that works with a lower ceiling, almost all these lifts are not ANSI certified.

How strong is a 4 inch concrete slab?

A concrete patio slab should be at least 4 inches thick and have a

compressive strength of 3,000 PSI

. You’re free to make it thicker or stronger, but unless specifically required for your patio build, it’s likely overkill to surpass 4 inches in thickness.

How thick does the concrete need to be for a car lift?

What’s better 2 or 4-post lift?

A

four post lift takes up much more room than a two post lift

. A two post lift will raise a car “higher” in a low ceiling garage. … If you have a 10 foot ceiling, the two post lift will raise most vehicles to about 6 feet off the ground. A four post lift makes it much easier to load and position the vehicle.

How tall does a garage need to be for a car lift?

How much space do I need? A car lift will optimize any space, so don’t fret if you’re concerned that your garage is too small. The car lift itself will fit into one bay space and it is optimal to have

11-12 feet clearance height

. Garage Living can also modify how your garage doors open to accommodate a car lift.

Can I install a lift in my garage?

You can put a car lift in your

garage

, as there are units that will work in a home garage, provided it is well installed, and your garage meets specific requirements regarding the thickness of the concrete floor and the height of the building.

Where should a 2 post lift be in a garage?

There are no golden rules for auto life positioning. In general, we suggest

at least two feet of space between your posts/vehicle and the side walls

. Any less and you will struggle to move around your vehicle when it’s on the lift.

Should I put plastic under concrete?

A

concrete vapor barrier

is any material that prevents moisture from entering a concrete slab. Vapor barriers are used because while fresh concrete is poured wet, it’s not supposed to stay that way. It needs to dry and then stay dry to avoid flooring problems. … This is why a vapor barrier under concrete is essential.

How strong is 6 inches of concrete?

For example, a 6-inch pad with a compression strength of 700 psi can support

1,105 psi

. If it was 7 inches thick, it could support 1,194 psi, and if it was 12-inches thick, it could support 1,563 psi.

Is rebar better than wire mesh?

Considering the support constraint,

rebar is undoubtedly stronger than wire mesh

. Several constructors consider rebar for domestic jobs. For thicker driveways and locations that involve greater traffic, rebar is always a good option to consider.

How much room do I need for a 4 post lift?

1. Space and Measurement. Your garage needs enough space before you can install an auto lift. The typical measurements for a 4-post car lift is

103 inches wide by 173 inches long

.

What size anchors for 2 post lift bolts?

These are

3/4′′ in diameter and 5 1/2′′ in length

. This is the most common wedge anchor used when installing many 2 post and 4 post auto lifts.

Does a 4 post lift need to be anchored?

Unlike 2-post lifts, which absolutely need to be bolted down, 4

-post lifts disperse weight across a wider surface area

and are engineered to lift vehicles with or without drop-in anchor bolts . …