How Much Does It Cost To Replace A Clock Spring?

by | Last updated on January 24, 2024

, , , ,

For a clock spring, the parts alone will cost $80 to $150; however, if a professional mechanic is going to replace the clock spring for you, the average job will cost anywhere from $200 to as much as $400 .

Can you drive a car with a broken clock spring?

A bad clock spring can afflict you with more than broken volume controls. You could be left without cruise control, a functioning horn, or most importantly, a functioning airbag. In this situation, you would be unable to alert an inattentive driver and the airbag may not deploy in the event of a collision.

How do I know if my clock spring is bad?

You can no longer answer phone calls or hang up using your steering wheel buttons. Rubbing noise when you turn the steering wheel –This is one of the early warning signs that the clockspring is starting to fail. Eventually, the clockspring will wear, and the ribbon inside the clock spring will break.

How do you replace a clock spring?

  1. Remove Steering Wheel Bolt Cover Clips.
  2. Remove SRS Airbag Control Module Bolts.
  3. Remove the SRS Airbag Control Module from the Steering Wheel (make sure you disconnect any electrical connectors)

When should I replace my clock spring?

On some older models, the wiring inside the clock spring can become brittle and break over time, causing failure. The clock spring may need to be replaced if it is damaged during careless service to the steering system , and, in some cases, if the vehicle is in a crash and the driver’s airbag deploys.

What causes clock spring failure?

Clock springs may become faulty with age due to electrical ribbons and their connections wearing thin . They also are likely to fail if they are not replaced after a car crash in which the airbag was deployed. Common signs you have faulty clock spring include: Illumination of the SRS/Airbag light.

What does the clock spring control?

In vehicle steering systems a clock spring or clockspring is a spiral-wound special rotary electrical connector which allows a vehicle’s steering wheel to turn while still making an electrical connection between the steering wheel airbag and/ or the vehicle’s horn and other devices and the vehicle’s electrical systems.

How do you fix a clock spring?

While it is sometimes possible to repair a damaged clock spring , it is generally better to buy a new one. Clock springs are cheap, and it’s important to have a reliable unit since they may be involved with the correct function of the driver’s airbag, the horn, cruise control, and traction and stability control systems.

How do you remove a clock spring?

  1. Remove Steering Wheel Bolt Cover Clips.
  2. Remove SRS Airbag Control Module Bolts.
  3. Remove the SRS Airbag Control Module from the Steering Wheel (make sure you disconnect any electrical connectors)

Is a clock spring hard to replace?

They are not hard to do and sometimes the s-wheel will come off without a puller. Don’t sweat the airbag, unplug the battery and just do it. They are cheap.

Does the clock spring control turn signals?

Commercial Member. The clock spring is separate from the multifunction switch that controls blinkers . Sounds like you got something put together incorrectly.

How do you test a clock spring?

You can no longer answer phone calls or hang up using your steering wheel buttons. Rubbing noise when you turn the steering wheel –This is one of the early warning signs that the clockspring is starting to fail. Eventually, the clockspring will wear, and the ribbon inside the clock spring will break.

Is a clock spring covered under warranty?

The warranty only covers the clockspring , and that’s only because it is required for the driver airbag to work.

Why are clock springs so expensive?

Any breaks or connection failures in the electrical system can cause an open circuit or short circuit in one of the systems. A short-circuited electrical system can cause a higher airbag clockspring replacement cost.

What is another name for clock spring?

Alternative names for the clock springs are clock spring coil, coil assembly, cable reel assembly, coil spring unit and contact reel .

How do I remove a VY clock spring?

Airbag clock spring replacement overview

This particular part is located between the steering wheel and the steering column. A clock spring is a flat cable that is wound in a spiral shape that looks similar to a clock spring. The average clock spring repair is going to take less than one hour .

Charlene Dyck
Author
Charlene Dyck
Charlene is a software developer and technology expert with a degree in computer science. She has worked for major tech companies and has a keen understanding of how computers and electronics work. Sarah is also an advocate for digital privacy and security.