Put
six ounces
of Synthetic ATF or fork oil/hydraulic oil into each leg.
How much oil do you put in your forks?
Slowly squirt
10cc of oil
into the forks. It is important to note that as the 10cc of oil goes in, 10cc of air must come out.
How much oil does a front fork take?
It's
about 200ml of oil
.
How much oil do dirt bike forks hold?
In most cases,
10-20cc's of
oil will be adequate, however, it's important to make sure you have your manual's recommended amount of oil in your fork.
What happens if you overfill fork oil?
If it's really over filled, then
the forks become rock hard and the springs that are in the forks are more or less there for the ride as
the “air spring” which is the air volume above the fluid level begins to dominate everything. So, if your forks are overly stiff, yes, too high oil level might do that.
Can you add fork oil without removing forks?
You will need to remove the caps to refill the fork tubes with oil. … If they do, you are in luck and will be
able to change the oil without
removing the fork legs. Put old newspapers on the floor under the front end. Place a drain pan under the fork legs and remove the drain plugs, one side at a time.
How do I know if my forks need oil?
Some indicators for basic bath oil/seal service = leaking around seals,
excessive oily dirt goo build up on top of seals that reappears on every ride
, visible wear on stanchions(by that time it's too late).
Can you use motor oil in dirt bike forks?
motor oil works
well in the outer chambers of twin chamber forks
.
What can I use instead of fork oil?
Peanut Butter
, and in some cases jelly…………. Many motorcycle supply shops also sell fork oil if you're having a hard time finding some. Massage oil is the real secret! After all you do want to keep the insides working good and what better way then to have massage oil working it.
Can I change fork seals without disassembly?
Yes
. Pull the bolt out that secures the cartridge to the lower fork leg and the forks will come apart. Put a seal in with a split type fork seal driver. Then you pull the cap and separate from cartridge to pull the spring to set the fork oil level.
How do you fill front forks with oil?
The simplest way to add oil to a fork is with
a graduated syringe that has a tip on it small enough to fit in the air-bleed screw on the fork cap
. Use the graduated scale to siphon 10cc of fork oil into the syringe. Noleen sells an affordable syringe for $6.95. Call them at (760) 948-1677.
Can you add fork oil through bleeder?
You can add fork oil through the air
bleeder with a small syringe
. To remove oil, you will need to remove the fork legs from the bike and turn them upside down to drain oil out of the air bleed holes.
Can I use engine oil as fork oil?
ATF is close to most
7-10w oils
. If you must, use that as your damper oil. For straight lubricating oil (like in the lowers of a Fox 40), motor oil is just fine.
How often should you change fork oil?
The oil in your fork loses lubricity, gets dirty, and should be changed every 10,000 miles or
once a year
.
Can you ride with a bad fork seal?
You should notride with a bad fork seal
for many reasons, safety being number one. A bad fork seal could leak oil onto your brake calipers, resulting in trouble decelerating and stopping the bike. That, plus poor shock absorption and an unbalanced ride makes a leaky fork seal dangerous to ride on.
