How Much To Repair Harley Transmission?

by | Last updated on January 24, 2024

, , , ,

The work could be done in

8–12 hours

on a highly experienced mechanic thanks to all his skill set. It might take up to a week for someone who never did it before to do it.

How much does it cost to rebuild a Harley engine?

Parts and labor for an engine rebuild can cost anywhere

between $2,500 and $4,000

. Replacing bearings and seals, as well as taking the engine out of service, could be part of this type of engine repair.

How long does a clutch last on a Harley?

Tour riding a stock bike your clutch should last

over 100,000 miles

. Doing burn-outs with a 110′′ engine will shorten that life quite a bit. Keep it adjusted and keep good, clean fluid in your primary.

How do you remove a transmission from a Harley Davidson?

How do I know if my motorcycle transmission is bad?

  1. Lack of Response. Hesitation, or outright refusal, to shift into the proper gear is a telltale sign of transmission trouble. …
  2. Odd Sounds. …
  3. Leaking Fluid. …
  4. Grinding, Jerking, or Shaking. …
  5. Burning Smell. …
  6. Won’t Go into Gear. …
  7. Service Engine Soon. …
  8. Noisy Transmission in Neutral.

How do motorcycle transmissions work?

A motorcycle transmission works

through the engine’s output being tied directly to the clutch through a covered chain/belt

. The clutch is tied to the input shaft of the transmission which has an output shaft that is tied to the rear wheel via sprockets and a chain/belt.

Is it cheaper to rebuild or replace an engine?

Yes. A scheduled overhaul is almost always less expensive than a new engine.

Rebuilding to repair is usually cheaper than buying a new engine

, too. You may save up to half of the cost of a new engine by rebuilding.

What is considered high mileage on a Harley motorcycle?

For larger bikes,

50,000 miles and up

is considered high motorcycle mileage. But before you write off any models, consider that a properly maintained bike can last well past 100,000 miles! That’s why it’s important to think about the whole package, rather than motorcycle mileage alone.

How many miles can a Harley last?

Harley-Davidson motorcycles can last for

well over 75,000 miles

if well-maintained and ridden responsibly and there are many Harleys on the road with over 100,000 miles on them. Based on an annual mileage of 4,000 miles, one can infer that a Harley Davidson can last for more than 25 years.

How do I know if my Harley clutch is bad?

To tell if your motorcycle clutch is bad, you’ll need to look for signs such as

unexplained high revs and lowered gas mileage

. Other signs of a bad clutch may also include a stuck clutch lever, hard shifts accompanied by a clunking sound or jerk, and difficulty getting the motorcycle to shift gears.

What Harley models are being recalled?

  • 2008-2011 Harley-Davidson Road King (FLHR)
  • 2008-2011 Harley-Davidson ROAD KING POLICE (EFI) (FLHP)
  • 2008-2011 Harley-Davidson ROAD KING POLICE (EFI) (FLHPE)
  • 2008-2011 Harley-Davidson ELECTRA GLIDE STANDARD POLICE (EFI) (FLHTP)

Is 25000 miles alot for a Harley?

A motorcycle with more than 40,000 miles is considered a high-mileage bike, but if it has been well maintained, it could still be a good buy.

The maximum distance on a sports bike is 25,000 miles

.

How do you rebuild a 5 Speed Harley Davidson transmission?

What kind of fluid goes in a Harley transmission?

According to AMSOIL, the

20W-50 Synthetic V-Twin Motorcycle Oil

is recommended for use in the engine, transmission, and primary chaincase of most Harleys (see our Motorcycle Product Guide for more information).

How do you install a transmission on a Harley Davidson?

Is it worth replacing a transmission?

Rebuilding a transmission can save you a lot of money over the short-term, while keeping car payments out of your monthly budget.

For many, rebuilding their transmission is worth the initial cost

. Rebuilding a transmission may cost you twenty-five hundred dollars or more, which is a significant chunk of change.

What are the top 5 signs of transmission problems?

  • Refusal to Switch Gears. If your vehicle refuses or struggles to change gears, you are more than likely facing a problem with your transmission system. …
  • Burning Smell. …
  • Noises When in Neutral. …
  • Slipping Gears. …
  • Dragging Clutch. …
  • Leaking Fluid. …
  • Check Engine Light. …
  • Grinding or Shaking.

Can you drive with a bad transmission?

The Dangers of Driving with a Bad Transmission

During that time

you should avoid driving your vehicle

. This is due to the dangers that come with an unpredictable transmission. If there have been issues with the gears not engaging or slipping, this can cause the vehicle to unexpectedly start shaking when driving.

Why is 1st gear down on a motorcycle?


If you are caught in an emergency situation, you would continuously shift down the lever to reach its lowest point in panic

. And having the first gear at the bottom is a far better and safer option than the neutral gear.

Are motorcycle transmissions built into the engine?

The clutch in a manual-shift motorcycle transmission is typically an arrangement of plates stacked in alternating fashion,

one geared on the inside to the engine and the next geared on the outside to the transmission input shaft

.

How much does motorcycle engine rebuild cost?

How Much Does It Typically Cost To Rebuild An Engine? The parts and labor required for rebuilding an engine usually range from

$2,500 to $4,000

. It can usually involve replacing bearings and seals, as well as removing the engine for reinstallation.

Are Rebuilt engines as good as new?


Frequently, rebuilt engines are superior to even new car engines

because better parts are used, or design changes in parts correct problems with the original engine. Rebuilt engines are dependable, reliable and are backed by the engine manufacturers warranty program.

Do rebuilt engines last long?

A rebuilt engine can last for

upwards of 100,000 miles

, even though it may not have the same life expectancy as the original. By doing this, you can extend the lifespan of your vehicle by as much as two years, and by doing regular maintenance, you can extend its life even further.

How many times can you rebuild an engine?

In general, engine rebuilds are performed

between 500,000 and 1,000,000 miles

, which can extend the engine’s life and improve mileage.

How many miles can a Harley go before rebuild?

How Many Miles Can A Harley Go Before Rebuild? It should be able to travel well past

100,000 miles

if it is properly maintained. Loss of compression and/or oil consumption can signal the need for valve installation and set of rings right away.

Is 35 000 miles a lot for a Harley?

Generally,

high mileage on a motorcycle is anywhere from 20,000 to 50,000 miles

. For sport bikes, the high mileage number will be on the low end (usually around 25,000), while cruisers and touring bikes typically become high mileage in the 40,000- to the 50,000-mile range.

How many miles per gallon does a Harley 1200 Sportster get?

Engine and Powertrain

Both get a five-speed transmission. Both crank out 70.8 lb-ft of torque and are rated by Harley-Davidson at

48 mpg combined in mixed riding

. It’s worth noting than the 1200 Custom has a 4.5 gallon fuel tank, while the Forty-Eight

®

only has 2.1 gallons worth of capacity.

David Evans
Author
David Evans
David is a seasoned automotive enthusiast. He is a graduate of Mechanical Engineering and has a passion for all things related to cars and vehicles. With his extensive knowledge of cars and other vehicles, David is an authority in the industry.