ITEMIZED REPAIRS COST | Restring all Rotors Repair Single Rotor (incl. restring) Pull Slide Repair Slide Lock Solder work (ea. point) $30.00 +$20.00 each additional item | Remove Minor Accessible Dents $50.00 | All Other Dent Work $75.00/hr |
---|
How do you repair a trombone?
How much does it cost to re lacquer a trombone?
General Service Overhaul – Lacquer | Trombone (No Valves) $40-70 $480 | Slide only $60 $250 | Bell Section $250 | Trombone w/F Attachment $60-80 $950 |
---|
How do you fix a dent in a trombone bell?
How do you fix a trombone slide?
How do you fix a slide dent on a trombone?
How much does it cost to repair a trombone slide?
ITEMIZED REPAIRS COST | Restring all Rotors Repair Single Rotor (incl. restring) Pull Slide Repair Slide Lock Solder work (ea. point) $30.00 +$20.00 each additional item | Remove Minor Accessible Dents $50.00 | All Other Dent Work $75.00/hr |
---|
Can you fix dents in a trombone?
Can you solder a trombone?
What is lacquer on a trombone?
Lacquer. A majority of Edwards trombones are shipped with a
clear epoxy lacquer
. A lacquered instrument will maintain its clean appearance while protecting against minor scratches and other everyday wear and tear. Lacquer is sprayed onto the instrument after it is buffed and degreased.
How much does it cost to lacquer a horn?
Lacquer-Strip and Hand Polish
$250-$425
Primarily, a layer of lacquer or epoxy plastic on a horn can dull the sound and inhibit a quick response. From a practicality standpoint it is far easier to have emergency repairs and customizations performed on an un-lacquered instrument.
How much does it cost to Relacquer a trumpet?
How much does it cost to re-lacquer a trumpet? It will easily set you back
$250 or more
, depending on if you want them to strip off the original lacquer.
How do you get a dent out of a brass instrument?
Traditionally, dents were removed from brass instruments
using a steel ball threaded onto a rod
. The steel rod and ball are inserted into the bore of the instrument up to the point of damage. Pressure is exerted downward on the instrument while the rod is held firmly in a vise.
Why is a trombone called a trombone?
The word “trombone”
derives from Italian tromba (trumpet) and -one (a suffix meaning “large”), so the name means “large trumpet”
.
How much does it cost to fix a dented trumpet?
Dents. Dropping your trumpet and causing a dent can happen to anyone no matter their experience. Dents should be fixed as they can affect the sound produced depending on where the dent is located. Price: A minor dent will generally cost
between $20 and $50
repair.
Why is my trombone slide getting stuck?
When tuning slides get stuck,
it’s often caused by the chemical bonding of impurities left on it
. If the tuning slide doesn’t come free with a little pressure, then you need to take it to a technician. Again, you must resist the temptation to use pliers to free the tuning slide.
Why is my trombone slide scratchy?
But if your slide sounds scratchy it’s usually a good indication that
the brass outer tubes have begun to get dirty inside
. It’s not hard to clean a trombone, but be prepared to spend at least 20 minutes to do it correctly. And, as always, BE CAREFUL when disassembling and handling your trombone.
What is a trombone with valves called?
Bass trombone
Modern bass trombones have one or (more commonly) two valves which are needed to provide a fully chromatic low register down to the pedal range.
What note do trombones tune to?
The trombone is pitched in concert pitch (Bb=Bb), however it is called trombone in Bb. F-attachments should be tuned to
fourth line F
, thus allowing the bottom of the staff F (an octave lower) to be in tune in first position. Bass trombonists should tune their main tuning slide and their F attachments as above.
What are the parts of a trombone?
- The Bell. Since the bell is the largest part of the trombone, even those who aren’t familiar with the instrument can probably point out the bell. …
- The Bumper. …
- The Counterweight. …
- The Mouthpiece. …
- The Tuning Slides. …
- The Valve Slides. …
- The Water Key.
Do dents affect trombone sound?
Any dent that significantly decreases the size of the tubing will be an issue to the sound, intonation, or air flow of the instrument
. A special component of the trombone is the main slide, which consists of the inner and outer slides. Trombone dents can be a significant problem if located anywhere on either slide.
How much does it cost to silver plate a trombone?
Silver Plating Gold Plating | Trumpet / Cornet / Flugelhorn One-piece $50.00 $120.00 | Trombone One-piece $60.00 $170.00 | Tuba One-piece $70.00 $175.00 | Saxophone Mouthpiece $50.00 $120.00 |
---|
How much does trombone spit valve cost?
This item Bach Trombone Water Key Spit Valve Cork Rubber Gasket Seal Pad – Set of 2 Liyafy 10mm Diameter Trumpet Cork Pads Repair Parts Water Key Spit Valve Cork Pads 10Pcs | Price $8 95 $9.99$9.99 | Sold By Harmony Music Jiayouy | Are batteries included? No No |
---|