- Open the doors on both sides of the vehicle below where the roof bar is mounted.
- Unlock the outer housing or lockable knob at the base of the feet using the Thule key that came with the set. ...
- Twist the knob on the foot counterclockwise to loosen the clamp.
How do you remove a Thule foot kit?
How do you remove a Thule roof rack?
How do you change a Thule Foot Pack?
How do you remove a Thule roof rack without the key?
How do you remove a Thule bike rack from a hitch?
How do you remove Thule straps?
How do you remove a roof rack?
- Unscrew the mounting screws from the roof rack siderails with a Philips screwdriver. Each siderail will have at least one screw on each end of the rail that secured the rack to your roof. ...
- Pull the entire roof rack from the vehicle roof and place it on the ground. ...
- Pull off each no slip strip.
How do you remove locking roof bars?
Can roof racks be removed?
Removing Aftermarket Roof Racks
Aftermarket roof racks are typically much easier to remove. Most simply clamp around your side rails or door jamb and can be removed by loosening a few bolts . Once you’ve done this a time or two, most roof racks will only take about 5-15 minutes to remove.
How do you remove a Thule Hullavator?
Removing a Hullavator isn’t too hard – in the up position (arms retracted on top of cross bars), unlock the swing-arm and tip it up (so it’s vertical but not extended/lowered) and pull it out (extend the swing arm) just an inch or two, then yank out the removable pin with your free hand.
How do I remove Thule SnowPack?
On the Thule SnowPack ski carrier # TH7326 first make sure the feet of the carrier are unlocked. Then turn the tensioning knob counter clockwise to loosen the straps enough to pull the one end free from under each foot .
How do you replace a Thule clamp?
How do you open Thule cargo without key?
Remove the plastic lock cap and expose the metal key hole and lock barrel. Position the drill bit into the dead-center of the metal barrel. Carefully bore out the lock cylinder . Take great care to go in straight and not drill the plastic edges of the cargo box.
