The certified technicians at MyAirbags recommend
resetting your vehicle’s airbag module
if the vehicle has been involved in an accident. Reset airbag modules eliminate the need for any additional programming, and, when properly installing the module back in your vehicle, the airbag light will turn off.
Can you reset airbag module?
All airbag control modules can be reset and reprogrammed
, with the exception of flood, fire or hardware damage.
Do airbag modules need to be programmed?
Replacing an SRS airbag module can be a lengthy and challenging process. When you install a different module in your car, used or new, you will need
to program it to your VIN
, which requires the dealer to do it.
Is it safe to reset airbag light?
You can reset the airbag light on your vehicle from your home garage
, saving yourself a trip to the dealership or mechanic. … But there are other circumstances that may cause the SRS light to turn on, such as after the installation of a new radio or there a malfunction within the airbag system itself.
How much does it cost to get an airbag module reset?
This process can take several hours of time and usually costs
a few hundred dollars
, although depending upon the type of car it may be up to about $600.
Can you drive without airbag module?
While a vehicle can still run without an airbag module, it is strongly recommended that
drivers do not operate the vehicle without it being installed
—unless an emergency situation arises and there is no other option. … Without airbags deploying, a driver and any passengers can face severe injury or even death.
How do I know if my airbag module is bad?
You can easily tell if the sensor is functioning if the
airbag warning light on the dashboard is illuminating every time
you start the vehicle. But, if the airbag warning light stays illuminated after starting the vehicle, this is an indication of an airbag sensor problem.
How do I get the airbag light to turn off?
- Turn on the ignition switch with your car key. …
- Wait for the airbag warning light to turn off. …
- Turn the ignition switch of your car back off for a little longer than three seconds.
- Repeat steps 1 through 3 twice to make three times total.
Will disconnecting the battery reset the airbag light?
Often, all it takes to get rid of that pesky warning light is to reset your airbag sensor. …
Remove the terminal clamp and leave it disconnected for 5-10 seconds
to allow the airbag sensor to reset. Then reconnect the battery terminal and turn the vehicle on. With a bit of luck, the light will stay off.
What does it mean when the airbag light stays on?
The airbag light indicates
that something is wrong with the seatbelts or airbags
. This means that it’s probably not safe to drive with the airbag light on. If it stays illuminated in your vehicle, we recommend having it towed to the dealership rather than driving it yourself.
How long does it take to replace airbag control module?
The repair work is expected to take
about 2 hours
to complete, depending on dealer schedules. While repair times can vary from 1 to 2 hours, wait times might be longer depending on dealer schedules.
Can I replace airbags yourself?
For those of you who want to replace airbag units on your own, you’ll be happy to hear
there are no restrictions on this kind of work
. You don’t need to go to any sort of authorized dealer or mechanic to fo this work, except when the work butts up against your car’s warranty.
Where is the airbag module located?
The location of the airbag module differs from vehicle to vehicle, depending on the make and model of it. In some vehicles, it is located in the center console, kick panel, under the radio, or behind the steering wheel. Generally, though, it can be found
underneath the driver’s seat or front passenger’s seat
.
Can you cut your airbag out?
Since the airbags deployed, they are no longer usable and would
be removed by a repair facility
as a part of the overall repairs. If you choose to cut them off so you can drive the car, there is no affect on the insurance.
Is it safe to drive with a airbag light on?
Is it safe to drive with an SRS light on? … It doesn’t necessarily mean that the car isn’t safe to drive but it’s like playing with fire if you do. When this light is on it means your
safety system isn’t working at 100%
and in some cases, it could mean that your airbags are disabled and will not deploy in an accident.
What does the airbag light look like?
The SRS warning light on the dashboard usually looks like a side view of a person sitting in a seat with a seat belt on, with
a large circle (the airbag) in front of the person
. It will normally light up briefly each time you start your vehicle, and then go off.
