The table saw is typically thought of as the workhorse of the woodshop, as it is likely the most versatile and productive of all woodworking machines. This one tool can
rip, cross-cut, miter-cut, square, dado, rabbet, and even apply shapes to edges of wood stock
.
What can you not do with a table saw?
- Do not reach around and over moving blades.
- Do not feed the work piece faster than the saw can accept.
- Do not lift the guard or work near the blade while it is turning.
What is the main purpose of table saw?
In its most basic form, a table saw consists of a rotary sawblade poking through the center of a flat worktable. Equipped with fences and guides, its primary purpose is
to cut solid wood or manmade boards into more manageable sizes
.
What can you do with a portable table saw?
For on-site work, a portable table saw is more practical than larger, heavier table saws. It rips and crosscuts; it miters and cuts compound angles, rabbets, and tenons. It can also
function as a shaper and a sander
, when equipped with appropriate blades.
What are the dangers of a table saw?
The teeth on the blade can cut off fingers
. The rotation can make the workpiece into a hazardous projectile and throw it back at the operator at high speed (“kickback”). It can eject a spray of saw dust particles, fragments from metal embedded in the wood, such as staples, and broken blade parts.
Which type of stock should never be ripped on the table saw?
Round stock
should not be ripped on a table saw. 18. When making bevel cuts, always keep hands and stock to the right of the saw blade.
What side should the fence be on a table saw?
You always want the work piece to be between the table saw blade and the rip fence. As a result, the rip fence can actually go on either side of the blade. A general rule of thumb is placing the rip
fence on your dominant hand side
. Most people use the rip fence on their table saw for safety purposes.
How long should a table saw last?
They can last
between 12 and 120 hours of continuous use
, depending on the quality of the blade and material they're used to cut.
How do I get the most out of my table saw?
- Use the right blade. There are specific blades for most tablesaw tasks. …
- Give it plenty of room. …
- Provide outfeed support. …
- Keep the tabletop clean. …
- Align the blade. …
- Invest in a dado set. …
- Use dust collection. …
- Level the throat plate.
What causes kickback on table saw?
The two main causes of injury from kickback is
trauma from the wood striking the head, chest, or torso of the woodworker
, or the wood moving so quickly that an operator doesn't have time to take their hand off of it and it gets pulled across the saw blade.
How do you stop a table saw kickback?
When it comes to preventing kickback, the best tool for the job is either
a riving knife or a splitter
. Each of these plates sits aft of the blade and, when properly aligned, as shown in Photo B, keeps the workpiece against the fence to deny it access to the rising rear saw teeth.
Why do circular saws kick back?
Kickback happens
when the saw blade binds or stalls suddenly in the wood and the saw gets driven back toward you
. So the key to preventing this is to make sure your blade doesn't bind in the wood. … Make sure you're using sharp blades and never force the saw through the cut.
What should you do before leaving the table saw?
Stand in line with the saw blade. After a cut has been completed, what should the operator do before leaving the Table Saw?
Make sure the saw blade has stopped turning
.
