As stated above, a defective instrument cluster and a blown fuse are common reasons. ... There are tons of configurations and instrument cluster designs out there. If it happens that all your gauges stop working at the same time, the problem is only caused by two things. It's either by a wiring problem or a fuse problem.
How do I reset my instrument cluster?
Push and release the Sel/reset button button 3 times repeatedly. The instrument cluster begins its self-test. Each successive press of the Sel/reset button initiates a new cycling of all the gauges. To end, turn the ignition switch to OFF, or vehicle speed exceeds 1.5 mph.
What causes dashboard gauges to stop working?
When one gauge stops working, the problem may be in the gauge itself or a bad sensor , while all the gauges cutting out at the same time often indicates a blown fuse or a defective instrument cluster.
Where is the fuse for the instrument cluster?
The instrument panel fuse block is located in the instrument panel , on the driver side of the vehicle. To access the fuses, open the storage compartment. Press in on the sides of the compartment to release it from the instrument panel.
What are the symptoms of a bad instrument cluster?
- Dim instrument cluster lights.
- The check engine light coming on sporadically or permanently. ...
- Intermittent failure of the gauges.
- Inaccurate gauge readings. ...
- Blinking lights.
- The lights glowing up or lighting up every now and then.
Is there a fuse for the dashboard?
Find the fuse that powers your dashboard lights.
Check under the hood, under the dashboard , or near or in the glove compartment. ... Refer to your owner's manual if you have trouble locating the fuse boxes or the dashboard light fuse. If you have more than one fuse labeled “lights,” you'll need to check them all.
Is there a fuse for a speedometer?
If the mechanic believes that a fuse or bad wire has caused the speedometer to stop working, he or she will begin by examining the fuse to check if it has been blown. If so, the mechanic will replace the fuse.
How do I fix my RPM gauge not working?
- Check the Fuses: If the fuse is blown, remove it and replace it with a new one.
- Recalibrate: If the calibration is out of sync, reset the tachometer. ...
- Check the Wire Connections: If the wiring is the problem, check the manual for the wiring diagram.
Does a used instrument cluster need to be programmed?
The cluster does not need to be programmed however you need a cluster from a supercharged car otherwise the display will show incorrect part fitted, also the connector on 1999 & 2000 cars are not the same.
How do you know if fuse is blown?
Look at the fuse wire. If there is a visible gap in the wire or a dark or metallic smear inside the glass then the fuse is blown and needs to be replaced.
Where is the fuse for the instrument cluster on a 2003 Chevy Silverado?
The instrument cluster fuse is located in the instrument panel on the 2003 Chevrolet Silverado.
How do you fix dash lights that won't light?
- Locate the knob or dial that controls the brightness of the dashboard lights. ...
- Make sure the brightness control is turned on. ...
- Check the fuse that controls the dashboard lights (see How to Fix a Faulty Car Fuse).
What problems can a bad instrument cluster cause?
Signs of a bad instrument cluster include dim/flickering gauges, inaccurate or unreliable readings, all gauges dropping to zero while driving, and an unworkable instrument cluster . These error symptoms can result in your vehicle going out while driving, displays failing occasionally, or complete/intermittent failure.
Can a instrument cluster be fixed?
If your instrument speedometer cluster is malfunctioning, we can provide you with repair and return services that you can trust! ... Within just 24 hours of receiving your damaged part, our technicians will make the repairs, test it, and send your fully functioning instrument cluster back to you!
How much does it cost to fix dashboard lights?
On average a mechanic will charge you $951 to replace the dashboard lights in your vehicle.
