This is info i had come up with, F08 indicates that the
heater is an open circuit
. Check the heater wires for dislodged or burnt wires and check the heater for continuity with a meter.
How do I fix e01 F08 on my Whirlpool washer?
A F08-e01 error code shows
when there is a lack of water supply going to your washer
. First you should check to see that both the hot and cold faucets are turned on and connected properly to your washer. Both faucets need to be turned on in order for the washer to run correctly.
What does f08 error mean?
F08 indicates that
the heater is an open circuit so check the heater for continuity with a meter
. F12 relates to an element short or the heater has failed completely so replace if necessary. Fault code F09 on some machines is an overflow error, which indicates that water has been found on the base of the appliance.
What does F8 mean on Hotpoint washing machine?
F8 –
Heater relay stuck
.
As above
this fault indicates a problem with the heating system in your machine and could also be caused by the pressure switch.
How do I read a whirlpool error code?
| Error Code Error | rL or F34 Items were detected in the washer during the Clean Washer cycle. | Sud or Sd There are too many suds in the washing machine. | F5 E2 The door is not locking properly. | F7 E1 Indicates a motor speed sensing error, |
|---|
How do I reset my washing machine?
To reset your washing machine,
unplug it from the power outlet
. Then, plug the washer cord back into the wall. Finally, open and close the washing machine door six times to send the reset signal to the system components.
What does F03 mean on a washing machine?
The F03 error code indicates that the washer has
a fill problem
, a drain problem or a failure in the water level pressure switch. Press STOP and fill the washer without any clothes in it.
How do I reset my Whirlpool Duet Steam?
Unplug the washer for 30 seconds
to attempt to reset the Duet washer control. if your fill hoses have a flood stop check valve turn the water off, disconnect the hoses and run a little water into a bucket. Then reconnect the hoses to your washer and do a Duet Washer Quick Diagnostic Test.
How do I fix error F8 E1?
- Unplug the washer or disconnect the power for one minute.
- Plug in the washer or reconnect the power.
- Re-select the cycle and press Start.
How do I reset my Hotpoint washing machine?
Locate the “
On/Off”
button. You can find the button on the left side of the control panel. Press and hold the “On/Off” button. Release the button after three seconds.
What does F5 mean on the washing machine?
A temperature sensor resistance
that is out of the normal range is detected by the Central Control Unit. A failed NTC temperature sensor is what causes the F5 error.
What is the problem with Whirlpool washing machines?
The extra current that runs through the machine when the heating element is on can cause the
door locking system to overheat
. The company said the issue had been identified by its safety team, but had led to fires, although none had been significant enough to cause more than minor damage or cause any serious injuries.
How to Confirm You Have Reset Your Whirlpool Washing Machine. … Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds.
When you turn it back on it should be reset
.
How do I reset my Whirlpool front load washer?
The first way you can reset whirlpool washer top load is by
unplugging it for about 2 minutes then plug it back in and wait about 30 seconds before starting the washer again
. This performs a hard reset on the machine and it will start over after you reconnect it again.
