U1110 means lost wheel speed message.
U1120
means lost wheel distance message. The Powertrain Control Module (PCM) doesn’t receive a wheel distance message from the Anti-lock brake Module or FCM (NON-ABS) over the CAN C bus. One trip fault.
What is a U1120 code?
means
the abs module isnt talkin to the speed sensor
. if you can locate the abs module unplug it and clean it with electrical cleaner. then clear the code and see if it comes back. if that doesnt work it is probably either the pump module or the speed sensor.
What does Lost wheel distance message?
U1110 means lost wheel speed message.
U1120
means lost wheel distance message. The Powertrain Control Module (PCM) doesn’t receive a wheel distance message from the Anti-lock brake Module or FCM (NON-ABS) over the CAN C bus. One trip fault.
What does U1110 code mean?
U1110-
LOST VEHICLE SPEED MESSAGE
.
Set Condition
: The PCM doesn’t receive a vehicle speed signal from the Anti-lock brake Module or FCM (NON-ABS) over the CAN C bus.
What is P0501 code?
P0501 is an OBD-II generic code that the
engine control module (ECM)
got an input from the vehicle speed sensor (VSS) that is out of range or an erratic voltage output that is not stable or smooth, with movement up or down.
What is code U1412?
U1412 is
Implausible Vehicle Speed Signal Recieved
. Usually caused during communication between the PCM and ABS module. Should be checked out by the dealer.
What does U1411 code mean?
Code U1411 =
Implausible fuel volume signal
.
What does system voltage low mean?
Diagnostic Trouble Code (DTC) P0562 stands for “System Voltage Low.” It
is triggered when the PCM detects voltage supply drops from the calibrated threshold for certain periods of time
. All electrical components in your car need a power source in order to work.
What is code U0121?
Code U0121 stands for
Lost Communication with Anti-lock Brake System Module
. Anti-lock brakes are required on all modern vehicles. The antilock braking system (ABS) prevents wheel lockup by modulating the brakes in an emergency situation.
What causes U0100 code?
Code U0100 is typically caused by one of the following:
A faulty PCM
.
A problem with the control module circuit
.
A problem with the CAN bus
.
What is an ABS module?
The ABS control module is a
microprocessor that runs diagnostic checks of a vehicle’s antilock braking system and processes
information from wheel-speed sensors and the hydraulic brake system to determine when to release braking pressure at a wheel that’s about to lock up and start skidding.
What is code P0730 mean?
What the P0730 code means. P0730 is the OBD-II generic code for
an incorrect gear ratio detected in an automatic transmission
. The ratio of a combination of engine speed and throttle position and the speed of the transmission is used to determine what gear the transmission will use when driving.
Can you drive with a bad speed sensor?
Can you drive with a bad speed sensor? In general,
it is unsafe to drive a vehicle with a broken wheel speed sensor
. The car’s computer will not be able to determine the speed that your vehicle is traveling, so it might apply the brakes at a faster rate than necessary or increase the engine power.
What does code po700 mean?
P0700 is set when the PCM detects a
malfunction in
the transmission control system. This malfunction causes the vehicle to set a Check Engine Light and trigger a failsafe mode. Once the failsafe mode is set it will remain until the fault is repaired or normal operation is detected.
