The red “key” light is telling you that
the security system is operational
. The fact that it goes out after you start it up means that the security system is disarmed.
What does the red light mean on a motorcycle?
Amber: There’s a fault somewhere – take extra care and have a look as soon as possible. Red: There’s a serious fault on your motorbike –
stop driving as soon as it is safe to do so.
What does red light mean on speedometer?
Like the red light in a traffic signal, a red light on your dashboard means
you should stop right away
. A vehicle with a red signal shouldn’t be driven until it has been checked and cleared by a mechanic. … You’ll see this light if the parking brake is still on or if the vehicle’s hydraulic system has lost pressure.
Why does my Harley security light stay on?
It could be something as simple as one of your signal or running lights is out. The key light
stays on if you have a blown bulb
.
Where is the speed sensor on a Harley Davidson?
Step 1 – Locate the speed sensor
The speed sensor on the Harley Davidson Softail is located
in the transmission, at the back, and below the starter motor
. Getting to it isn’t easy, but replacing it is once you are there.
Can you go through a red light on a motorcycle?
A motorcycle or bicycle is
permitted to run a steady red light after making a complete stop and waiting at least 45 seconds
and then yields the right–of-way to any vehicular traffic or pedestrians using the intersection.
When can you run a red light on a motorcycle?
They would have to stop completely and
wait at least three minutes
. If the light stays red, and no vehicle or pedestrian is coming to that intersection, then the motorcyclist can carefully proceed through the red light. Would this law come into play in a motorcycle accident?
What is the red dot on a Harley speedometer?
It means
a turn signal light bulb is out
…or something else interfering with the security system on your bike.
What does the red car with a key symbol mean?
The red key warning light means there
is a security error code
. This light illuminates when the vehicle control modules see the ignition turned with a key that is not programmed to the vehicle or when there is an error within the security protocol of the vehicle’s security system.
What does an orange engine light mean?
The orange, engine-shaped icon on your car dashboard’s instrument cluster is
programmed to turn on when the vehicle’s electronic brain detects something is wrong
. Don’t panic if you see it — it doesn’t necessarily mean you’ll need to give your next paycheck to the nearest mechanic.
How do you reset the security code on a Harley Davidson?
- Ignition switch to on.
- Immediately press both turn signals at the same time (red key light on you speedometer will flash rapidly if done right)
- Press and let go the left signal 2 times.
- Press and let go the right signal once.
- Press and let go the left signal 5 times.
- Press and let go the right signal once.
How do I know if my Harley has security?
Registered. One way to tell for sure is to determine whether your bike has
a Turn Signal Module(TSM)
or a Turn Signal Security Module(TSSM) installed. TSM = no security system TSSM = security system. On the side of the module there should be a sticker with a H-D part number.
Where is the speed sensor on a motorcycle?
Most current motorcycle speedometers use a sensor triggered
by the teeth of a transmission gear or a similar dedicated ring or by the slots in an ABS wheel ring
. These sensors send a square-wave signal to the ECU, which calculates speed from the frequency of the signal.
What do you do when you get a red light on a motorcycle?
A motorcyclist should ideally
keep the left foot down, right foot on the brake and the bike in gear at the
traffic light. Obviously, that needs you to hold the clutch of your motorcycle to dis-engage the clutch plates. This position allows for an immediate throttle apply and release of the clutch under a sudden threat.
